dude, if you are putting in a new deck just by a wiring harness from a parts store, audio video store, radio shack or even Walmart. do not go through and try to clip the wires and wire it up yourself- wierd stuff will happen. Lights will stay on when they shouldn't, turn the turn signal and it turns off the radio etc. I will run between 12 and 15 bucks. Worth the money.
1997 Plymouth voyager will not start if i disconnect the camshaftsensor plug wire it wii try to crank
my neon does the same problem . jus lift the dask and jiggle the wire harness .there are two connections ,the one closest to the radio becomes loose
A 1996 PLYMOUTH VOYAGER IS NOT INTERCHANGEABLE WITH A 1993, IT HAS TO BE A 1993 TO A 1995. SOME FUEL PUMPS HAS A 3 WIRE CONNECTOR, AND SOM HAS A FOUR. THE FOUR WIRE IS A MORE EXPENSIVE FUEL PUMP.
The input speed sensor is the two wire sensor on the front of the transmission case closest to the engine.
I am assuming that you want to know how to wire up a new radio replacing the Infinity radio that was in the vehicle. The URL below tells you how to do it in a Plymouth Voyager. http://www.installdr.com/InstallDocs/DCP/PDF/327001.pdf I also found the following URL helpful in explaining a lot abot the infinity system. http://allpar.com/stereo/infinity-guide.html
That should go somewhere to the frame as a frame ground.
who really cares this is a really dumb question i searced "purple potatoes" and got thid question
Follow the upper radiator hose to the engine. Look for a two wire sensor behind the thermostat housing and under the coil. That is it.
It might not be under the carpet. It could be run up in the pilar and up above your head. Good luck.
Check for loosed connections. wire, Speaker's, exc.
You can't....a hangar is where you keep and airplane. But if you had a wire hanger, you would be able to untwist the wire hanger and then proceed to attempt to unlock the car -- but I think your best bet is to call AAA or a locksmith.
The main Ignition wire from the switch is dark blue, look under your steering column, and there are screws to separate a piece of plastic, directly behind your steering wheel, and you will see the dark blue wire coming from the switch