0
Timing and distributor position 1976 Cadillac eldorado fuel injected 500ci?
Wiki User
∙ 16y ago
With the flywheel timing mark aligned at zero, #1 cylinder (front left facing engine) should be at top dead center and distributor rotor should be pointing at #1 post (1st post clockwise past the battery connector on the dist cap). If the distributor has been removed and reinstalled, the rotor may point at the opposite post (180deg out). If so, the distributor will have to be lifted enough to allow the rotor to be turned back to the #1 post. Be careful, if you try firing the engine with the timing significantly off, she will kick back into the starter, possibly damaging the starter gear or worse....! Once started, set the timing to 12deg btdc....good luck! Mike
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
Where is cam position sensor 1995 cadillac 4.9 liter?
under distributor cap 3 wireplug in harness .
Where do you find camshaft position sensor for 91 cadillac deville?
It's in the distributor also called a hall sensor.
Where is no 1 cap position 92 Cadillac 4.9?
According to about.com , # 1 position on the distributor cap faces towards the DRIVERS SIDE on the 1992 front wheel drive Cadillac models 4.9 L
Where is the number one position on the distributor cap on a 1987 Cadillac fleetwood 4.1 liter engine?
According to the ( about . com website ) - # 1 position on the distributor cap faces towards the drivers side The firing order is ( 1 - 8 - 4 - 3 - 6 - 5 - 7 - 2 ) The distributor rotor turns COUNTERCLOCKWISE On the 4.1 liter V8 engine in your front wheel drive Cadillac
What is the distributor position timing for 1987 ford mustang 2.3L fuel injected?
10 degrees BTDC ( unless engine compartment sticker shows different )
Where is the camshaft position sensor located on a 1991 Cadillac fleetwood?
Cam sensor is inside the distributor under pick-up coil. Some say whole distributor has to come out to replace, some have snuck it out by removing pick-up coil.
How do you install the distributor on a 1998 Nissan Pathfinder?
mark position of old distributor on motor and on old dist, also mark position of rotor. Remove old distributor, mark the position on new distributor, move rotor to the marked position, drop in
Where is the crank sensor located on a 92 Ford Tempo?
The 92 tempo doesn't have a crankshaft sensor. However the multi-port fuel injected models do have a Camshaft Position Sensor located near the distributor.
What replaces the distributor on a fuel injected motor?
On cars without distributors, the engine relies on sensors to send fire to the plugs. Sensors are commonly used to find the position of the crankshaft to determine the proper time to fire the plugs.
Where is the crankshaft position senor located on a 2003 Cadillac deville?
where is the 2003 Cadillac Deville Crankshaft Position Sensors located
How do you remove a distributor on a 1976 Ford 302?
Assuming you have set the engine to #1 TDC and marked the position of the distributor and the position of the rotor, remove the distributor hold-down clamp and it's bolt, then pull the distributor up and out.
Where is the cam position sensor on a 97 Nissan pickup?
It is part of the distributor. You have to replace the distributor
