well it depends on the lacquer and thinner types....
synthetic thinner and lacquers also when applied by spray usually takes several hours but dont take the risk without checking the specifics of you products....
why hurry?
I am a world before I am a man I was a creature before I could stand I will remember before I forget BEFORE I FORGET THAT! Yeah, yeah, yeah, yeah Yeah, yeah, yeah, OH!
Before the Common Era.
The duration of Before We Forget is 3240.0 seconds.
This Never Happened Before was created in 2006.
Once Before I Die was created in 1965.
yes I've tried it before.
You should find out about the cost and available space.before refinishing my bathtubs.
scrape off the lacquer paint first. by means of sand paper #100-140 before applying the latex paint
Lacquer on wood seals it and gives a shiny appearance. Other paint or stains will not penetrate this finish, so if you wish to stain or otherwise colour your wood you must do it before putting lacquer on.
It depends if you are wanting to stain or merely paint a door. If you want to stain it, you need to strip it to bare wood with chemicals. If painting you need to sand the entire surface only enough to rough the surface so the new paint will adhere. If you are changing the stain and finish, after you remove all the old stain wait a couple hours before you restain. Then apply a coat of polyureathane or lacquer to seal it.
Finally getting around to refinishing that hardwood floor? Unless you've done this before, don't dive into a living room or kitchen. Start with a smaller room, perhaps a tiny bedroom. Make sure you know exactly what type of wood you're dealing with. White or red oak, Brazilian cherry, maple; each type of wood is complex and may require a unique approach to staining and refinishing. Take time to check with your local home construction and improvement store or website before plunging in. You will get a far better handle on what this type of work will require.
Mixing clearcoat with paint, will ruin the paint.For enamel paints, make sure you use an enamel clearcoat. You should allow the paint to fully cure (at least a week) before attempting to apply the clearcoat. Never use a lacquer based clearcoat on an enamel based paint. It will ruin it.For lacquer based paint, you should only use a lacquer based clearcoat. The paint should be dry, but does not have to be fully cured, since the lacquer will wet the coat of paint below it anyway.
Orbital would be enough for refinishing. Much less chance of damage to the floor also. Unless you have used one before or the floor needs leveling, a belt sander can ruin a floor very quickly.
It removes paint (lacquer or enamel), varnish (or shellac). READ the label CAREfully before purchase for the exact type of finish you wish to remove.
Used to dilute, dissolve and clean up lacquer products. Typically too caustic for oil paints, lacquer thinner is often used for removing inks on metal, and adhesive residue from a variety of surfaces. Lacquer thinner is very strong and rapidly deteriorates many surfaces and fabrics. Always test in a small inconspicuous area before applying too liberally on a large surface. Hope this helps!
The range for bathtub refinishing work from a licensed and bonded contractor varies, but you can expect to pay anywhere from $340 to $900 total. This amounts to approximately $1.50 to $4 per square foot. You should definitely check someones credentials and sign a contract before ever agreeing to pay someone for their work.
NO, worst thing you can do ! -strip ALL old caulk off and clean edges with lacquer thinner or acetone before re-caulking.