answersLogoWhite

0


Best Answer
I had the same problem with my 1998 dodge ram 2500 truck. The power locks stopped working on both sides and quit responding to my remote unlock button. I read that if you disconnect the battery, things will reprogram....Well, I simply disconnected the red cable for a couple minutes and when I replaced it, the power locks worked!! Even with the remote!

I had the same problem with my 2005 town an country,i was told by a dealer that all you have to do is disconnect the battery for about five minutes.It worked for me..................good luck

well i guarantee that does not work on 95 corsica as a matter of fact disconnecting the battery worsens the other problem were having with it stalls while cornering moderate acceleration and sometimes just real hard to start

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Power door locks and keyless entry stopped working and all door switches are in good shape and is master relay located under driver seat or if not where is it located or other possible solutions?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the keyless code located for a 03 town car?

where is the keyless entry code for a Lincoln twoncare located for a 2003


Where is the keyless entry code on 1999 ford expedition?

The keyless entry code is located below the driver window on the exterior


Where is the keyless entry code located on a 2007 Lincoln MKX?

where can i find the master keyless entry code for a 2007 lincoln mkx


Location of keyless entry module on Ford Econoline?

The keyless entry module, on your Ford automobile, is located in the engine compartment. The module is bolted to the firewall.


What do you check for a non-working keyless remote after battery replacement on a 1996 Infiniti I30?

It is possible that the tiny electronic momentary switches that activate each of the keyless entry functions have gone bad. Usually they don't all go bad at once but the one most used (Lock and Unlock) may begin to fail first and it may seem like you have to push real hard to get it to activate. It takes a bit of electronic prowess to unsolder these micro switches that are mounted on the small printed cirsuit board located inside the plastic housing, and install the new ones. I did it and mine now works fine. I had to locate the switches online. I drive a 2000 i30t which is a few years newer than a 1996 and three of the four micro switches had gone or were going bad. It may be prudent, if you dont want to go through all that I went through to accomplish this, simply to go through the nearest Infiniti dealer and you can purchase a replacement.


Where is the door light switch located on a 2007 dodge charger se located?

4 switches, one on each door, the front door switches are located on the front door pillar and the rear door switches are located on the center pillar, just look for a push in button on the pillars and that's the switch.


Where is the Remote Keyless Entry module located on a 2002 buick regal?

According to AllData, it is located behind the IPC.


Where is the sensor located for keyless entry on a 2009 Chrysler Town and Country?

The ignition switch, also called the wireless control module, is the keyless entry computer and receiver.


What is remote keyless entry?

A remote keyless system is a system designed to permit or deny access to premises or automobiles. the exact phrase "keyless entry" is solely reserved for the numeric dials or keypads that are located on or near the driver side door.


Where are headlight dimmer switches located in 1940 autos?

floorboard


Where is the keyless code located on a 2008 ford crown Victoria?

It should be located on the inside of the trunk on one of the arms that supports the trunk.


Where is the keyless entry code located on a 2005 ford 500?

Should be located behind the driver's door panel on control box