0
Hey Tony==The crank sensor is on the rear of some jeeps attached to the bell housing. It in itself won't cause overheating. If you have electric fans, make sure they are operating properly. Make sure the radiator is flowing coolant and not have a bunch of build up. Good luck Joe
Wiki User
∙ 6y ago
Wiki User
∙ 15y agoOn a 4.0l the crank sensor is located on the transmition. Driver side, near the top of the bellhousing at about 2 O'clock looking from the front of the truck at the engine. The wire conector is near the back of the intake (3 wire connector i have heard of a 2 wire connector instead but i have never seen it) you can follow to the crank sensor (top of tranny).
Wiki User
∙ 14y agoOn the back of the engine, under the firewall, driver side. You can barely see it from above. You have to change it from underneath.
Add your answer:
Earn +20 pts
Where is the crank shaft sensor in a 1996 jeep Cherokee sport Straight 6. 4.0 liter?
The crank sensor is located on the top of the bell housing on the drivers side.
Where is the maf sensor located on a 2004 Jeep Grand Cherokee?
It does not have a mass airflow sensor.
Where does crank sensor get power from on a 1996 jeep Cherokee 2.5l?
The PCM (engine computer) provides the power.
I own a 2001 Jeep Cherokee that didn't start the day after a mechanic did a tuneup on it he replaced the crank sensor do 2001 Jeep Cherokees have crank sensors and if so is that a legit diagnosis?
yes
Where is located the crank position sensor on a 1996 jeep grand Cherokee Laredo?
its on the bell housing,on the tranny,driver side.towars the top,held in by one bolt.sets inside the bell housing.
Where is the output crank sensor located on a 1995 jeep Cherokee grand Laredo?
in a toilet
Where is the crank position sensor located on 96 Jeep Grand Cherokee Lardeo?
It is on the top passsenger side of the bell housing.
Where is the crank position sensor located on a 96 Jeep Grand Cherokee Laredo?
It is on the top passenger side of the bell housing.
If a 92 Jeep Cherokee will crank over but will not start what is the problem?
probably crank sensor, they are famous for that
Where is crank sensor on 99 jeep 4.0 grand Cherokee?
driver side on the back of the motor where is crak sensor on 94 jeep 4.0 grand Cherokee
How do you bypass a crank sensor in a Jeep Cherokee?
You can not. The crankshaft position sensor is required to run the engine.
Where is the crank shaft sensor in a 1996 jeep Cherokee sport Straight 6. 4.0 liter?
The crank sensor is located on the top of the bell housing on the drivers side.
Will crank position sensor interfer with ignition module on a 1994 jeep Cherokee?
The ignition module uses the crank sensor to decide when to spark.
Does the 1997 jeep Cherokee have a crank sensor or a pickup coil?
It has both.It has both.
Where is the crank sensor located on a 1997 jeep Cherokee lardeo with a 4.0 engine?
Driver side of the bell housing at about 2 o'clock if looking from the front.
Where is crank sensor on a 1993 Jeep Cherokee 5.2 l?
It should be on or near the throttle body.
Where is the maf sensor located on a 2004 Jeep Grand Cherokee?
It does not have a mass airflow sensor.
