How to reset the maintenance light after oil change?

already exists.

Would you like to merge this question into it?

already exists as an alternate of this question.

Would you like to make it the primary and merge this question into it?

exists and is an alternate of .

turn the key to the accesories position. pump the break pedal 3 times. the check engin light should flash. then turn the key to the off position and then start the car. the light should reset.
I am not sure if that works I have a 2004 Odysey and I did this and it worked.
While the car is off, push and _hold_ in your Trip meter button, then while still holding that button in... turn your ignition key to _On_ (not start). Wait until light goes out or you need a hair cut... which ever comes 1st. LOL, seriously it should go out in about 15 seconds or less
For a 2007 Honda Odyssey: Turn your ignition to the On position. Press and hold down the trip meter button for ~10 seconds (until the display blinks). Release the trip meter button. Press and hold the trip meter button a second time for ~5 seconds (until the display shows your oil at 100%). Then after all this is done you add oil to the tank and put a lighter in your car seat and wait 15 minutes until you can get back in your car. Then start engine and relax. and remember not to follow any directions after the turn the key part. Thanks.

Not sure what vehicle you have but, the correct procdure would also be found in your drivers manual.
91 people found this useful

How do you reset the maintenance oil change light on a 2005 Honda Civic?

HOPE THIS HELPS...ON MY ACURA(TOP-FLIGHT-HONDA) THERE IS A MAINT. REMINDER ON THE DASH THAT TURNS AMBER AT MAINT. INTERVALS. YOU STICK YOUR MAIN IGNITION KEY INTO A RESET SLOT

How do you reset the maintenance light for oil changes on a 2007 Toyota 4Runner?

Turn the 4Runner on, make sure that you are looking at the "odometer" miles and not the "Trip" miles. Turn the 4Runner off, hold the "reset" button, turn the 4Runner On and th

How do you reset the maintenance light for oil changes on a 2007 Honda accord?

This works on GM cars not sure about for honda. Put your key into the ignition and turn it to the on position hit your gas pedal 3 times turn the car off and now start it. Thi

How do you reset the maintenance light for oil changes on a 2008 Honda Accord?

1. Turn the ignition switch to the ON (II) position. 2. Press the select/reset knob a couple of times until the engine oil life indicator is showing. 3. Press the select