Every 5,000 miles, a "Maintenance Required" light will blink for the first couple seconds after you start your car. It will continue to do so until it is reset. If it is not reset, than it will eventually turn on your "Check Engine" light. The purpose of the maintenance required light is to remind TC owners to change their oil. The factory recommended interval is 5,000 miles, but you can reduce the interval the light will come on to a mileage interval of your choice.
1. Before starting, make sure that the odometer is not on one of the trip mileage odometers but is displaying the standard odometer.
2. With the car off, press and hold down the odometer reset button. While still holding it, start the car.
3. The light should continue to blink for a couple seconds and than disappear. That will reset the light for another 5,000 miles.
4. The following are steps to change the interval in which the maintenance required light comes on. Right after you turn on the ignition while holding the reset button, you'll notice that the odometer display will show 5 bars. Each bar corresponds to a 1,000 miles. As each bar disappears, the interval will increase (0 bars = 5k, 1 bar = 4k). Release the reset button at the interval you desire.
how do i reset srs light on scion tc
change the oil
The check engine light is reset with a scan tool after repairing the cause of the fault.The check engine light is reset with a scan tool after repairing the cause of the fault.
The check engine light has to be reset with a OBD scan tool
You reset the check engine light with a scan tool after repairing the failure.
how do i reset srs light on scion tc
hoe do you reset the check engine light in a 1995 land rover
how do i reset the check engine light on a 1999 acura 3.2tl
The check engine light comes on in a car when there is a problem with the engine. It will go off or be reset when the problem is fixed.
You need a scan tool to properly reset the check engine light.
How do you reset check engine light for the 2009 Chevy trail blazer?
There is no reset button for the check engine light. It must be reset with an OBD scan tool.