0
Unplug sensor--- sometimes you can get a wrench on the sensor if not you will have to purchase the special socket.Genuine parts are often high so you can get the sensor at an auto store directions are included with the sensor as how to attach the pigtail and ude the heat shrink tubing suppied
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
Where is bank2 sensor 1 for Subaru outback h6 3.0?
Where is the bank2 sensor 1 located on a 2001 subaru outback 3.0
Where is the oxygen sensor located on your 1999 Subaru legacy outback sport utility sedan?
I just purchased new catalytic converters for my 1999 Subaru Legacy Outback. There are three ports for oxygen sensors. They appear to be on the top of the converters. I just purchased new catalytic converters for my 1999 Subaru Legacy Outback. There are three ports for oxygen sensors. They appear to be on the top of the converters.
How do you change a knock sensor on 1998 Subaru Outback?
that the knock sensor does
How do you replace a tps on a 1997 Subaru Outback?
Throttle position sensor on this vehicle is held on by two screws. It's a 10 minute job.
Where is the oxygen sensor on a 2000 Subaru Outback?
there are two. both along the exhaust under the car. one just before the catalytic converter and one just after.
What is the function of oxygen sensor in subaru?
The function of the oxygen sensor in a Subaru or any other car is to measure the amount of oxygen that is mixed with exhaust gases.
What happens in subaru with faulty oxygen sensor?
When a Subaru has a faulty O2 sensor the fuel management is out of whack.
Where is the crank sensor on my 1996 Subaru Outback legacy?
Directly below the alternator on the block.
2002 Subaru legacy outback code P 1137?
P1137: Front O2(oxygen) aka A/F(air/fuel) Sensor Circuit Range/Performance Problem.
Where is the Knock Sensor located in a 1993 Subaru Outback Impresa?
on top of the engine under the air box
Where is the Knock Sensor located in a 2000 Subaru Outback Legacy?
It is located on the engine block drivers side.
How do you replace 2001 Subaru Outback oxygen sensor?
the oxygen sensor is located between the fist and second muffler. you will need to disconnect the sensor and it will then unscrew out of the exhaust pipe. I just did this on my H6 and I also needed to replace the air mix sensors on each side of the motor. they look just like oxy sensors and my need to be replaced as well. they are located on either side of the headers. the best way to get at them is from under the hood. you will also have to disconnect these sensors from the top and then unscrew them from the headers on each side.
