0
i dont know why are u aksin me 4
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
How many yards of felt are in 11 rolls if each roll has 56 yards of felt?
616 yards
How many yards of toilet paper are on a toilet paper roll?
It depends on the size of the roll,
How many yards will a roll of sod cover?
1 yard
If you have a roll with width 72.835 yards and length 255 yards how many meters squared is that?
Area of roll = 72.835 yd x 255 yd = 18,572.925 yd2 = 15,529.33 m2
How many yards are in a 12 ft roll of carpet?
This varies greatly. Usually more then 100 sq yards, but less then 200 sq yards.
A roll of ribbon 120 feet is how many yards?
there are 3 feet in a yard so 120 feet equals 40 yards.
How many square feet in a roll 24 inches by 50 yards?
300 square feet.
If You use twenty seven inches of ribbon off of a roll of ribbon containing 2 yards How many inches of ribbon are left on the roll?
45"
Laura has a roll of ribbon there are 20 yards of the ribbon on the roll what can Laura use to find the number of inches of ribbon on the roll?
36 inches x 20 yards = 720 inches.
How do I convert square feet of carpet to yards. I need 40 yards but the roll says it is 1800 Square Feet of Tan Berber Carpet 12' x 150' - what is the formula to convert so I know how many yards?
There are 9 square ft in a square yard. So if you have 1800 square feet of carpet on this roll you only need to divide it by 9. So, the roll of carpet you are looking at is 200 yards.
How do you you thread a new holland 310 hay baler?
Place two rolls of twine into the twine chamber, pull the end of the twine from the center of the rolls. Thread the twine from each roll through the loops in the lid of the twine chamber. Each twine should go through the loop on the side of the lid that the roll of twine sits on. The left side through the left loop, the twine on the right side through the right side loop. Run the twine through the two tubes on the left side of the twine chamber. The again, the left through the left side, the right through the right side. Close the lid to the twine chamber. Run the ends of the twine through the porcelian electric insulator fastened to the needle carriage, then the ends of the twine through the eyes of the needles. Again, the twine from the left side through the left needle eye, the end of the twine from the right side through the eye of the right needle. Pull the ends back to the protective pipes surrounding the needles and tie the ends to the pipe. Raise the bale trip lever on the drivers side of the bale chamber so it will trip shortly after you power the baler. You will need a small amount of hay going through the chamber to do this. When the bale trip lever trips, the needles will come up and the knotters will grab the twine and hold it. You are now ready to bale.
Where do people usually have rock and roll dance today?
grave yards, rock and roll is dead
