how construction joints is done?
The reinforced concrete construction is the construction joint in water retaining structure.
Far too vague - define "construction joint " more accurately.
Dummp joint in retaining wall
a perpend is a vertical joint between adjacent masonry units
Basil Read Construction in joint venture with Bouygues Construction
A construction joint in concrete jobs is a joint where a fully set and hard concrete joins a fresh concrete to make a joint. Normally, cracks would occur at this joint because concrete was not cast monolithic. A contraction joint is joint between two concrete edges so formed which allows minute movement between the two edges caused by heat or some other external forces. Usually, contraction joints are also referred to as expansion joints.
Construction joints are very useful, the expansion & contraction made is made in summer & winter season respectiely. In summer coz of temprature concrete get expansion in mm but it damage the structure, that's why construction joint is provided. Sunil Nagargoje TESPL
Compression joint is a term typically used in construction. It's a bell and spigot joint that becomes watertight when the spigot is pressed into a compression gasket in the bell.
The construction joint should be placed where there is the least amount of impact. This could include the slabs. These types of foundations are used in the United Kingdom and Australia.
A construction joint is a separation of either vertical or concrete pours designed to offer movement in case of wind loading or other loads so as not to compromise the integrity of the concrete structure itself. The construction joint is usually joined together by non-metallic strap to hold the two slabs in place; at the same time giving flex when there is movement.
Compression joint is a term typically used in construction. It's a bell and spigot joint that becomes watertight when the spigot is pressed into a compression gasket in the bell.
A rabbit joint is used in cabinet making. See link