best way to test a relay is remove it from board, get a 9v square battery and touch the switching terminals on the relay, the relay should click if its working. You can then test resistance through the relay. You can also check the feed to the relay, if theres pwer to the switching terminals on the relay, chances are the switch it ok. If no voltage, switch or wiring.
I had an issue that I thought might be the relay switch, it was the connection plug on the frame just under the transmission where it crosses from the drivers side to passenger side. Maybe that is the cause as it was for me.
Tell me if just one window or all of them quit working
It is connected to the back of your Hazard Flasher. I just had to change mine. About $65.00 to $70.00. Couple of clips at the bottom of front panel then it just pops out.
a relay just plugs in literally
The starter relay switch is attached to the short positive battery cable; just follow it to the starter relay. I hope this helps you. Mark
Just wire it to a toggle switch. When you need it, just flip the switch.
If I'm not mistaken, it should be under the hood. Facing the car it should be on the right in the black box just above the battery.
It could be the indercator switch i just had the same fault on a Hyundai and it was the indercator switch
relay switch is on the inside middle of the firewall behind the radio do not have to take the radio out just go up beside the gas pedal and there it is
It could be a fuse, a relay the switch
yup, just need a they power window relay, window motor and regulator. (and a possible connector from the switch to the relay (located at the ffuse box)
The flasher relay is on the left of the driver side below the dash. Just pull it out.