If it is a 4.0, loosen the two rear steering pump mounting bolts, the upper pivot bolt, and the locknut and the adjusting bolt located on the bottom of the unit. Push the steering unit in and remove the old belt. Remember how it was routed. Replace with the new belt. Pull the steering pump back and tighten the adjusting bolt for tension. Then tighten the other bolts.
ATF +4 for an automatic.
any dot3
Should have an automatic belt tensioner - if tension not correct replace tensioner
he serpentine, or accessory belt.
Yes.
No.
It is a 42RLE.
The correct factory tire size for a 1994 Jeep Wrangler is 215/75R15.
No.
serpentine belt loose
Yes, it will fit just fine.
Certainly, they are both YJ"s.