How do you reset the oil change light on a 2004 Chevrolet impala?

already exists.

Would you like to merge this question into it?

already exists as an alternate of this question.

Would you like to make it the primary and merge this question into it?

exists and is an alternate of .

On many GM vehicles you turn the key to ON (do not start)then depress the gas pedal 3 times. The light will flash twice to indicate it received the info. Answer If that doesn't work, check the display panel on the middle of the dash. The info center can be toggled to get to the reset screen.
39 people found this useful

How Do you reset the Change Oil Light on a 96 Impala SS after you change the oil?

Answer . This is how to reset the "CHANGE OIL" light for a 96 Impala SS:\n1. Turn the key to the "RUN" position with the engine OFF.\n2. Push and release the gas pedal th

Reset oil change light 2000 impala?

Turn the key to run position Depress the accelerator pedal to the floor 3times in 5 seconds. The light should flash and the go out. Turn the key off and the start the engine.

How do you reset the Change Oil light on a 2004 Chevrolet Venture?

turn the ignition key to the on position (but do not start the vehicle) .Then push the trip odometer button a few times until the word oil appears on the screen. There will be

Reset oil light on impala?

Turn the key to the run position and depress the accelerator 3 times to the floor within 5 seconds. The light should blink and then go out.

How Do you reset the Change Oil Light on a 2003 Impala after you change the oil?

Easy.. turn the car on but do not start it. pump the gas pedal 3 times fast. turn the car off. then start the car. message board should clear. if not then try again. or you ca

How do you reset oil change light on Chevrolet Cobalt 2008?

On any GM vehicle, turn the key to the accessory position (TWO CLICKS FORWARD), then press the gas pedal to the floor three times in a row. Then start the vehicle. The light s