This is for 2011 Jeep Grand Chrokees with the push-button Start:
That's it! The oil change indicator is reset. Note that if you've disabled the seat belt alarm, you'll have to re-do that sequence too.
Two possible ways: 1. turn the key to run but engine off, then press the gas pedal down three times. Or there might be a red button in the fuse block in the car or in the juction block under the hood.
Turn the key to the on position. Depress the accelerator pedal to the floor 3 times within 5 seconds. Turn the key off, back on and start the engine. it should blink a couple of times and then go off.
take your hot wire off the battery and leave it off for about 15 min. this will give it time to reset. Good luck While sitting in your car turn the key on but do not start the car, press the gas 5 times quickly and return the key to off. This should work
turn the key in the on position without starting it and press down on the gas pedal three times and the change oil light should start blinking
turn the key forward to the on,but dont start it the press the gas petal 3 times and turn switch off the after that start it and see it that helps
With the key in the On position, fully depress the accelerator pedal three times.
You do not reset it, it is a fault code. It is not a routine maintenance indicator. Fix the problem and the light will go out.
if your refering to the service computer then its probably time for an oil change to reset it after you change oil hit select then set to reset comp to count down the 3000 mile service schedule.
Either reset with a scan tool, or by unhooking the battery.
Where is the fuel reset button on a 2000 jeep Cherokee freedom
scan tool or unhook the battery.
You do not reset it, it is a fault code. It is not a routine maintenance indicator. Fix the problem and the light will go out.
Check engine light is reset with a scan tool.Oil change due is reset by pressing "step" until "0 miles to service" is displayed. Then press and hold "reset" until it resets.
Open your owner's manual. Key on, doors closed. Press "step" until "0 miles to service" is displayed. Press and hold "reset" until it resets.
Driver side fuse box there is a switch you push to reset.
AnswerThe answer can be found in your owner's manual.Key on, engine off.Press "step" until "0 miles to service" is displayed. Press and hold "reset".
Key on, doors shut, press "step" until 0 miles to service is displayed, press and hold "reset" until mileage resets.
if your refering to the service computer then its probably time for an oil change to reset it after you change oil hit select then set to reset comp to count down the 3000 mile service schedule.
On your overhead console, hit "Step" until you see the miles to serice. Then you just hold your reset button and it will change to 3000 miles
Jeep does not use inertia/reset switches.
There is no reset for the fuel pump on a Jeep.
With the engine turned on and someone in the driver seat. Hit the step button until 0 miles to service appear, hit RESET. A beep will sound and it is done.
Renault Service - computer controlled indicator. You may change oil by yourself, but the indicator won't change until it is reset digitally. What does this mean?