Turn the ignition key to ON. Don't start engine. Press accelerator pedal to floor 3 times. Turn ignition off. Must do this within 5 seconds. Job done.
The instructions on how to reset the brake maintenance light in a Chevrolet Malibu can be found in the owner manual. It can be viewed for free at Chevrolet's official website.
After repair, you reset with a scan tool.
Carefully!!! You will need to pressure bleed the system and it will require a scanner to reset the light.
Turn ignition to auxillary pump gas pedal three times turn ignition off then back on light should be reset. also if you call jiffy lube and tell them they did not reset light they will give you process to reset.
Reset the change oil light on Mazda 3
Why? Just reset it.
The check engine light on a Chevrolet Colorado can be rest by connecting an OBD II code reader to the vehicle's computer . Each of the codes can then be reset which will turn the associated light off.
Your owners manual should tell you how to reset the light.
how do you reset change the oil light in a 2004 alero?
Turn ignition switch on, press accelerator pedal to floor rapidly 3 times, start engine and light should go out. Do not press more then 3 times as then it will not reset.
Change the oil........then turn the key to the on position,with car off pump gas pedal 3 times within 5 seconds. This should reset light
See {How to Reset the Engine Oil Life System} on page 5-21 of your "Owner's Manual", under Section 5: Service and Appearance Care.....