Try putting it into valet mode if not interested in using the system.
Put the key in the ignition, and turn forward all the way just before cranking. Then within 5 seconds, locate, press and hold in the valet/overide button, found under the dash area, (push button, spring loaded) until the installed LED (the blinking light) in your dash area goes on solid, and the siren chirps once.
(Your valet switch might be the toggle (on/off) type. in this case, key on, flip switch in opposite direction, then turn the key off.)
This should reset the alarm, and reset the grounded relay on the starter wire, allowing you to start the engine.
At this point, the only thing working would be the keyless entry from the alarm, if it came equipped that way.
Just Repeat these steps to place it back to usable armed mode. You may get 2 chirps, confirming it, and the lights may flash twice as well.
That should do it. If you want to remove it at this point, take it to your neighborhood installer for this, or buy the wiring chart for the vehicle, and reverse engineer it wire by wire, until safely removed.
If it does not work out this way, you will have to replace the system with one you know how to operate and what to expect. Don't want to get stuck in another bad situation.
ok
The Toyota 4 runner will not start, it sounds like it is going to and it will not, the starter, spark plugs are fine?
how to reset hornet alarm,, cause my car can't start..alarm still active,,
to reset the alarm system for a Mercury Sable when the alarm is causing the car not to start, place the key in the ignition. Turn the key only about halfway and leave it in this spot for 10 minutes before trying to start the car.
alarm does not work can not start car help
unplug the battery, this will reset the car with the alarm disabled
use the ignition key to turn to on or to start and the system should reset. I stopped using mine because it would trigger at any time wothout an intrusion
To turn off the alarm you hold down 'Reset' and press 'Start' Hope this helps!
Contact the dealer.
To reset the alarm on a Corolla 1993, place they key in the ignition and turn it until it clicks. Keep the key in this position for 10 minutes and then start the car as normal.
Hold down reset, then press start, the alarm bell symbol should dissappear.
Turn the ignition switch to the auxiliary position. Do not start the engine. Leave the ignition switch in the auxiliary position for 30 seconds. This will reset your alarm system.