This is not a easy job what engine do you have. You need the service manual without it it could be a impossible task.ps it a 3.8 engine
AnswerSupport the car with a jack stand and then support the engine with a jack under the oil pan (use a piece of soft lumber between the jack and the pan or you'll be removing the pan to fix it). Remove the passenger's front wheel. Remove the push pins holding the weather shield. Remove the shield. Remove the upper motor mount. Remove the belt. The belt tensioner is held in by two bolts. Raise the engine with jack carefully until you can get your hand in to remove the top tensioner bolt. Lower the motor with the jack very slowly until you can access the bottom bolt and remove it. The tensioner will come out through the fenderwell. Put the new one in the same way. Put the bottom bolt back, raise the engine, top bolt, level the engine, attach the belt, reinstall the motor mount, weathershield and wheel. If you forget the weathershield your belt might squeak when it rains. If this sounds like a pain in the neck, take it your local shop.The tensioner has a spring in it that provides the correct tension for the belt. If it is too loose, replace the tensioner.
u do not adjust belt tensioner if belt is loose, u need to replace belt as tensioner works automatically
Worn belt or belt that has stretched to the point the tensioner cannot keep the proper tension. The tensioner can also be defective. Replace the belt and the tensioner.
Remove beltUnbolt tensioner and remove
By locating and loosening the 'tensioner' for that belt, if the alternator mount does not include a tensioner.
Disconnect the battery. Rotate the belt tensioner to release the belt. Have a helper remove the belt while holding the tensioner. Replace the belt, putting the new one on over the pulleys in the same direction. The tensioner can now be released.
You have to unscrew the tensioner bolt and remove the serpentine belt first, then change the pulley and replace the belt.You have to unscrew the tensioner bolt and remove the serpentine belt first, then change the pulley and replace the belt.
How long will it take to replace a belt tensioner unit and serpentine belt in a lexus 1996 sc300?
There is no adjustment on the spring / Tensioner. You either have the wrong belt are the tensioner itself is bad. Replace tensioner are belt.
how do replace the belt tensioner on a 2006 toyota tundra. please tell me step by step
The belt tensioner should have a single mounting bolt. After removing the serpentine belt, the bolt can be removed to take the tensioner off.
Not usually