It's located in the front wheel well. Remove front left wheel, then unscrew battery door. Actually, there's no reason to remove the driver's side front wheel, just turn wheel to left and right behind the wheel you'll find an access panel, remove this and there's your battery. Recommend removing negative post first to prevent "short circuit" when removing positive terminal. Good Luck!
Charge it, test it, replace it.
Remove the positive battery cable from your 2001 Chrysler Sebring battery. Remove the cables from the starter. Remove the starter retaining bolts. Reverse the process to install the new starter.
100,000 miles
Yes
100,000 miles
The windshield washer pump on a Chrysler Sebring convertible is replaced by disconnecting the wiring harness and unbolting the pump. It can then be lifted from its mounting bracket and a new pump put into place.
To replace the transmission solenoid pack on a 1998 Chrysler Sebring, remove the air filter box, the battery, and the battery tray. Remove the 4 bolts on the frame and the trans cooler lines. The solenoid pack is screwed to the to the transmission with 3 10 mm bolts. Remove the solenoid pack and replace it.?æ
When replacing the alternator on a 2000 Chrysler Sebring convertible begin by removing the belt. Next, remove the wiring. Lastly, remove the retaining bolts. Reverse the process to install the new alternator.
It is not a direct swap. They use different transmissions, computers, wiring, etc.
6 hours
Because you didn't charge the battery.
The battery is in the front of the left front tire well. The manual says you don't have to take off the tire, but you DO. Remove a few screws at the front of the wheel well and you'll find the battery.