If your car has the 2.8 L engine the coil is on the ignition module which is located on the front of the engine below the exhaust manifold. Remove the two spark plug wires noting their positions so you can put them back in the correct place. Remove the two small screws that hold the coil in place, remove the old coil and install the new coil. Replace the two spark plug wires.
If your car has the 2.5L four cylinder engine the coils are bolted to the ignition module which is on the back of the engine below the intake manifold. Remove the two spark plug wires noting where they go back. Take the two small screws out and remove the old coil, then install the new coil and put the spark plug wires back in their proper places.
The 1988 Chevy Celebrity uses distributorless ignition. There is no provision to alter timing, the engine control module takes care of that.
The ignition module on a 1988 Chevy Celebrity with 2.5 engine is on the side of the block beneath the intake manifold. You can simply follow the spark plug wires to it. As information the crankshaft position sensor is behind the ignition module.
The 1988 Chevrolet Celebrity uses idistributorless ignition systems, the timing is controlled by the ECM. there is no provision for adjustment.
what is the wiring diagram for an 1988 Chevy celebrity stero
If I had to replace a fuel line I would get a replacement out of a car in a wrecking yard and install that.
How do i change the ignition switch in a 1988 Chevy camaro
what is the ignition timing for a 1988 Chevy 454 engine
The fuel pump on your 1988 Chevy Celebrity is in the fuel tank.
The fuel filter in your 1988 Chevy Celebrity is on the driver's side behind the rear wheel next to the fuel tank.
How do you change the ignition control module in a 1988 Chevy Silverado 5.7L
100 lb or above
In the fuel tank