OPEN THE GLOVE BOX DOOR ALL THE WAY DOWN TILL IT IS POINTING AT THE FLOOR NOW REMOVE THE VACUME POD THIS IS THE ONE THAT CHANGES THE AIR FLOW DEFROST /HEAT / VENT /AT THE LEFT SIDE OF THE DOOR THIS IS DONE BY PUSHING UP AND THEN SWING IT TWARDS YOU NOW LOOK ON THE TOP OF THE HEATER BOX UP HIGH NEAR THE FIREWALL YOU CAN SEE THE BLEND DOOR MOTOR IT HAS 2 - 5.5 MM SCREWS HOLDING IT ON THE HEATER BOX OH BOY THIS IS THE HARD PART ALL YOU NEED TO DO IS REMOVE 2 SCREWS I JUST DID IT 2 HRS AGO I USED A 1/4 IN DRIVE RACHAT AND A 5.5 MM SHORT SOCKET A THUMBWHEEL OR THUMBWHEEL RACHAT MAY ALSO WORK BUT IT CAN BE DONE WITH A 1/4 RACHIT HAVE FUN TAKE YOUR TIME DONT GET MAD IT WILL COME OUT.
Best place to get the replacement actuator (Doorman 604-106) is Amazon. $94 compared to local parts stores at $135 and up. Make sure you have a kid or wife handy as you'll need small hands and fingers to get up on the screws holding it down. You also need to disconnect the power connector going to it (not mentioned above). Lastly, the old actuator might be "stuck" and doesn't just pull up and off. Wedging a screwdrive between it and the housing it rests on will pop it up. OH...make sure if you have a Bravada that you get the above part # as its for the Automatic Climate Control system in the Bravada.
And there is a great write up with images too at this link:
http://www.automotiveforums.com/t574779-blend_door_with_pictures_and_the_common_problem_.html
How do i replace blend door motor
you can not pea brain
how to replace a blend door actuator on a 1999 ford ranger
assuming you are in an older bravada, simply pull the gear shift on the column upward and toward the drivers side door, then turn the key backward to remove.
Located in the transfer case. You need to remove front driveline, then remove three bolts holding motor. Pretty simple job.
To replace the blower motor on your 93 Bravada: Passenger side of the engine compartment, near the back of the compartment, there is a drum shaped component, usually black plastic. The blower motor slides into the center of this "drum" from the front of the compartment side, and is held in place by 6 bolts/screws. There is a short hose that connects to the blower motor and 2 wires. Disconnect the hose and the two wires, remove the 6 retaining bolts, and slide the blower out towards the front of the vehicle. You may need to remove the Engine Coolant overflow tank to remove the blower motor.
i would like to know the answer for myself
No you can not put any Oldsmobile motor into a 1985 Cutlass Supreme. Each car has a motor that was designed specifically for that vehicle. So if you need to replace the motor in a 1985 Cutlass Supreme, you need to find the specific motor for that vehicle.
One bolt at a time-cute but not helpful
The Relay is located on the Drivers Left hand side Firewall next to wiper motor there will be two relays(same part number for both)
Most offen its the encoder motor it is a electric motor the engauges the All wheel drive its located to the passager side of the transfer case and can be bought from auto parts store for around 170.00$ Thanks James
Depends on which motor you're referring to