My 98 gets pried off with a flathead screwdriver.
above passenger feet. remove cover, reach as far forward as you can, you will see the connectors.
In order to change the brake light, check your manual for directions. You will need to remove the cover and replace the burnt out bulb.
What do you mean by headlight cover?What are you trying to do?JW
remove the four bolts holding it on. scrape all of the old gasket off. clean both sides with brake clean, cover both sides in RTV, stick the gasket on, bolt it on, and tighten.
You need to remove the rear seat to access the speakers and remove the covers.
remove the spark plug cover. and the valve cover to reach it its right under the cam pulley
open trunk remove carpet over taillight remove retaning screws
Follow the upper rad hose to the engine. You will need to remove the engine cover. To remove the cover turn the oil filler neck (not the cap).
To change the license plate light on a Pontiac Sunfire, first remove the cover over the bulb with a small screwdriver. Gently push on the bulb and turn 1/4 turn to remove the old bulb. Insert the new bulb and snap in the cover.
First you remove the plastic engine cover on top of the valve cover. Then you remove the wires from each of the three coils, then you remove the bolt holding each coil and remove coil. Down in that hole is the spark plug, remove with socket and replace.
To replace a Pontiac Grand Am bumper cover, start by taking out either the three bolts on the side of the fender or in front of the wheels. Remove the top pushpins to remove the cover. Push back the two pins for each headlight, and pull them up. Unplug the lights. Then, get the replacement bumper, and snap it into place like the previous one.
remove oil cap tube then lift it up