answersLogoWhite

0


Best Answer

Never heard of this but I have had some onery tubes in the past. Cut the power off the light. Grab the tube and turn it anticlockwise 1/2 turnv while pulling down lightly No? Then try clockwise. No?

User Avatar

Bria Cummings

Lvl 10
2y ago
This answer is:
User Avatar
More answers
User Avatar

Wiki User

6y ago

It depends on the exact type of dome fixture.

1. Some have 3 screws holding the globe in. It is just a matter of unscrewing all 3 thumb screws most of the way and wiggling the globe loose. To put it back, you make the lip of the globe clear the screws so the globe is flush with the fixture and then evenly tighten all the screws.

2. For some, the globe screws into the fixture. If there are no visible screws, and the globe doesn't want to shift and has no give to it if you lightly tug at it, then you can try unscrewing the globe. If that works, then it is just a matter of screwing the globe back on when you are done with the bulb.

3, Then of course are the kind that are held together with a leaf spring. They are very tricky, and this type is often installed in hard to reach locations. You have to carefully pry the globe and if you can reach the springs, you should push them with your fingers to take pressure off the inside of the globe, and you keep pulling the globe. Putting it back together is more difficult, since you have to bend the spring leaves back out and feed them into the globe, and maybe pull at the globe to keep it from slamming into the fixture and breaking.

This answer is:
User Avatar

User Avatar

Wiki User

11y ago

Remove the clear lense of the dome light. They just clip in place. Behind the lense where the bulb is you should see a couple screws that mount the light to the headliner. Remove those screws and drop out the light fixture. You should have 1 or 2 wires maximum to disconnect on the rear. You should just have to pull the tab up to disconnect them. They are typically not hard wired in.

This answer is:
User Avatar

User Avatar

Wiki User

14y ago

pop off the lens and remove bulb

This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you remove the dome light in a jeep Cherokee sport?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where do you go to order a rear dome light cover for a 1999 jeep Cherokee sport?

Dealer.


Radio dome light fuse in a jeep Cherokee?

need location of fuse for dome and radio.


How do i remove the dome light cover in a 2007 ford explorer?

how do i remove the dome light cover on a 2007 ford explorer suv


Where is the switch that controls the domelight turning on when the tailgate is opened on a 1997 jeep Cherokee sport?

There should be a front dome light and a rear domelight. on the rear domelight push it in aka click it while the tailgate is open and it will turn both dome lights off.


Where is the tailgate dome light switch for the Mitsubishi montero sport?

The Montero Sport's tailgate dome light doubles as the switch. The entire clear plastic cover slides left to right and has three positions. ON-DOOR-OFF


Where is the keyless entry module located on a 1998 jeep Cherokee sport?

Inside the dome light fixture. Slide it forward about 2 inches and it will drop off the clips. Control module is mounted inside the cover.


How do you remove the dome light cover on a 1999 Toyota Avalon?

It


How do you remove dome light cover 2000 Tahoe?

You can remove the dome light, in your 2000 Chevy Tahoe, by inserting a small screwdriver into the locking slot. Gently pry downward with the screwdriver.


Can you manually close the sunroof on a 2003 chrysler sebring?

Yes, if you remove the dome light you should be able to turn the motor with a screw driver.Yes, if you remove the dome light you should be able to turn the motor with a screw driver.


2005 ford crown Victoria How do you disable the dome light from turning on when the door opens on a 2005 ford crown Victoria?

There should be a SWITCH at the dome light! If not, remove the fuse from the fuse box above where your gas pedal is. OR: Simply remove the BULB from the dome light. duncanw.


How do you replace the dome light in your 2005 Toyota?

To replace the dome light in your 2005 Toyota, you will need a flat screwdriver to remove the screws and pry the dome light cover from the light. You can then access the light to change the bulb or replace the entire bulb and cover.


How do you replace the dome light bulb in a 2002 Chevy cavalier?

You can replace the dome light bulb in a 2002 Chevy Cavalier by first prying the dome light cover off of the light. Then, remove the bulb and replace it by twisting the bulb from the socket.