Hammer and chisel to scrape it off, an assortment of putty knives.
If the cement is not too old, try water and a soft scrub brush.
Use petrol or paint tinner...
form_title= Vinyl Floor Tiles form_header= Easy to clean and easy to install- Vinyl. Do you need to remove old flooring?*= () Yes () No What color do you want the tile?*= _ [50] What are the dimensions of the area?*= _ [50]
Heat the vinyl with an old electric iron and use a scraper.
they are new vinyl strips with wood textured surface and adhesive backing for easy installation. please advice if it is applicable to the mosaic floors and will not bubble up due to moist underneath when the room temperature is low.
No if the old floor is only one layer, smooth, and not curling.
Not directly as the ceramic tiles will soon show through the vinyl flooring. If the ceramics are laid on a wooden floor, you must take up the tiles and overboard with 6mm plywood. If the tiles are on a concrete floor, you can leave them down and lay a latex screed on top to provide you with a smooth floor for your vinyl
It depends on the type of floor that you are putting down the vinyl flooring on top of. If it is concrete, then make sure it is clean, dry and repair any cracks or holes. If the old vinyl flooring is in good repair then just put the new vinyl flooring over it or use an embossing leveler for slightly worn vinyl flooring. If the old vinyl flooring is in very poor shape remove it completely. Plywood underlayment can be used for other types of flooring that you will put new vinyl flooring down on top of.
If the stain is not too old, vinegar will lift most of it out.
It makes a better finished product to remove the old flooring first.
Yes - but a qualified yes. If you are talking about the 12" square vinyl floor tiles that are still securely fastened then you can go right over them. If they old tiles are lifting or loose then the answer would be no. If only one or two tiles are loose then you can remove those ones - and with a patching / floor leveling compound fill in the voids so that the entire floor is smooth and level. If you can not find a patching compound try using a modified latex thinset (for tiles). It sticks to most things and is relatively cheap and will last longer than the sheet vinyl floor. If many of the tiles are loose - remove them all. The old adhesive is starting to fail and will cause problems after you install the new floor. There are several ways to fasten sheet vinyl flooring the most common being glued down. Check the manufacturer's instructions on what the acceptable substrates are. I would highly recommend first washing (to degrease) then scuff sanding the old tiles to promote adhesion.
There are a few kinds of sheet vinyl. Most glues will come off most vinyl if you can get hold of an edge and simply peel it off.