You;ll need an injector removal socket from Kent Moore or a Snap-on dealer.
I took the bed off (held on by 6 nuts), and then removed the gas tank, which is held on by 6 nuts). Was pretty simple actually. Was able to remove the pump and clean the tank thoroughly.
the injectors could be dirty buy fuel injector cleaner or the machanic could take them out and clean them
Remove the fuel rail, the injector just pulls out. Make sure area is very clean. Replace all o-rings.
Your distributer might have a crack in it and moisture is getting in to it and grounding it out,inspect it,wipe clean and check.
Try jumping it off. If it cranks remove the + side on the battery. If it shuts off the alternator is bad .If it does not shut off clean the battery terminals . Have the battery checked at the Auto Zone.
A bad fuel injector can cause a miss fire especialy when you load the engine up like pulling a hill. You may want to invest in have a three stage injection clean the fuel rail and injector.
buy a bottle of fuel injector cleaner to do that job for you
Aircompresser
No its just to clean your injectors the fuel injector cleaner will just go right through the filter it wont do anything to filter.
Fuel injector cleaner that you mix with a tank of gas, doing anything else to your fuel injectors to try to clean them can, and will likely end up damaging the injector itself, or the o ring seals that maintain fuel pressure. I have changed my injectors myself before, and they don't usually come out easily, or without breaking the plastic electric connector. Good old injector cleaner from time to time will do wonders, and keep system running smoothly.
Go Down to your local part store and by the best fuel injector cleaner for your car.
check accelerator for correct adjustment; check gas flow in each injector; check air filter; check turbo; Clean out the banjo bolt and clear tube on the back side of the intake manifold on the passenger side. Make sure the tube is clear all the way to the ALDA on top of the injector pump.