There are screws holding the headlight assy in. Remove them and take the bulbs out and stick a rag into the light and move it around with a screwdriver.
However, even if it looks like the yellow is on the inside of the light but if it's like most Sebrings the haze is on the outside. Try a product called Crystalenz it works and is easy to use. Their website is www.crystalenz.com, also when you use this product you do not have to remove the lenses.
Plastic headlight covers need to be buffed with rubbing compound used to restore paint
To clean the inside headlight lens on a ford ranger just simply remove the cap and clean.
The same way you clean the outside. Tip: Remove the headlight first to get access to the inside. Pretty simple, should only take 2 or 3 beers.
The headlight assembly is sealed, cannot remove the cover. The bulb inserts from the rear, in a socket held in place by a tubular locking device. The bulbs can be a pain to install correctly. Do not touch the bulb with your bare fingers, it will cause it to build up heat and blow out again shortly. Clean the bulb with denatured alcohol and then hold it with gloves or a piece of cloth when you insert it. AJ
you have to take the front bumper off from underneath your car to get to the lights.
The headlight assembly can be changed, but not just the actual clear lens on the front. See "Related Questions" below for how to remove the headlight assembly, and also how to clean them
Yes
There are a number of Headlight cleaning kits available, some work, some don't. Google Clean your headlight lens, and call or research the companies to find the best.
If you have composite headlights, you can remove the bulb, remove the headlight assembly, use some headlight lens cleaner, rinse it out, and let it dry. If you have sealed beam headlights, you can only change out the assembly or clean the lenses only on the outside.
There are colored links in three places on the chain. It helps to clean the chain with brake cleaner to find them.There are colored links in three places on the chain. It helps to clean the chain with brake cleaner to find them.
Support the car on jack stand. Clean the area to remove mud and grease. Use 9/16 inches socket wrench the four bolts. RemoveÊthe cotter pin. Remove the ball joint.
Remove door panel where switch is located. Remove itch. Use fine emery board nd clean points. It worked for me