0
How do you reattach the convertible top to the bottom of the rear window on a 1992 Lebaron Convertible?
Wiki User
∙ 15y ago
Have a '03 Corvette Convertible and did the following:
1.Clean surface, unlock the top and place a 2" spacer to relieve stress on window interface.
2.Apply thin coat of 3M Glass Primer [08682 or 08681] to the glass area to be glued -10 min dry time.
3.Apply 3/16" bead of 3M Windo-Weld adhesive 10.5 oz tube [08609] over primer - Press the surface of the top around the window to provide a good contact and extrude excess adhesive.
4.Prop up the window from inside the car to provide good contact between the glass and top - this is important. I also placed some Duct Tape in a few locations at the window top interface to assist in holding the top to glass. Cover top to protect from rain - leave top unlocked with spacer.
5. I let it cure for 3 days because of my outdoor weather conditions, but the curing conditions [Temp/RH] can be found on the 3M Web Site.
6. Carefully clean excess adhesive with razor blade.
7. Cost about $25. Materials can be ordered online or at a body shop supplies retailer.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
1996 lebaron convertible and it has the 3.0 in it and there is a sound coming from the left side and water pouring out the right bottom of the motor what do you think it is?
It could be a water pump.
Where is the MAP sensor on a 1986 lebaron?
Where is a maf sensor on my 1986 Chrysler labaron convertible 2.5 tbi engine
Where is the convertible top drive relay located e46 BMW?
The BMW convertible top drive relay switch can be found in the fuse box. The convertible top drive relay switch will be at the bottom of the third column.
How do you remove the rear power windows on a 1991 Chrysler LeBaron convertible?
You have to remove the back seats.. and then the panels.. windows are held in by 10mm bolts.. disconnect the connectors at the bottom if the window unit.. Allow an hour to do this.. PIA job
What is the difference between a 1987 325I BMW convertible fender and a Sedan fender?
Hi the difference in the convertible to a sedan is the back of the convertible fender is longer and will not work. If you are looking to repair rot on the bottom of a fender you can use the last five inches of the sedan fender, no more.
What is a convertible hand truck ?
A convertible hand truck is a metal frame with two wheels on the bottom used to push boxes around with ease. These can be purchased at any hardware store such as mansards.
Where is the transmission filter in a 2001 Chrysler Sebring convertible?
It is on the bottom of the transmission, inside the pan.
Where is the release valve for the raditor on a 1996 Sebring Convertible jxi?
Look at the bottom or rear of the radiator
How do i repair the convertible top window if it came loose at bottom in a 00' cavalier?
glue it with clear epoxy
Do bronco ll have convertible tops?
I own a 1987 Bronco II 4x4 XL with a 2.9l V6 engine that was converted when new to a convertible. I have the original window cost sticker. At the bottom it says Memo Consignment Sherrod Van Lines at Florence Tx. As I understand it Sherrod did the conversions. I have seen pictures on the internet of one other 1988 Bronco II convertible and it too came from Sherrod. So at least a few have convertible tops
On a 1996 sebring convertible 4 cyl.Does the engine come out through the top or out the bottom?
The engine is removed out of the bottom with the trans at the same time.
Where is the transmission fluid reservoir on 1999 Chrysler sebring convertible jxi located?
The oil pan on the bottom is the fluid reservoir.
