The answer is: it depends on the transfer case. Generally, though, one can change from 2 Hi into 4 Hi by simply pushing the transfer case lever into the appropriate indendt. 4LO is different. Generally to go to 4LO, one must be moving VERY SLOWLY and accompish the shift while everything is moving. That being said, I doubt you'll need 4LO lest you are doing some serious climbing or heavy towing. Again, the best answer is to read the owners manual or check over the driver's sunshade to look for instructions for your particular configuration.
Put the lever into the 4wd position.
No... The Liberty is by default a rear wheel drive SUV with the option of connect the front axle to change to a 4WD mode.
Apply the parking brake.
2002 jeep liberty limited four wheel drive is stuck in 4 low how do I get it unstuck?
If you have a lever, pull it into the four wheel drive position. If a switch, put in four wheel drive.
no, the transfer case must be installed in the jeep in order to drive it
Put the transmission in the neutral position,then shift the vehicle back in to 2 wheel drive
That is 4 wheel drive. You are allowed to drive in that range on slippery surfaces.
Yes there is, but you have to walk a little, unless you have four-wheel drive, then you can park in the site.
The rear brakes is the normal location but it could also be the front or on the drive shaft on a rear wheel drive.
The rear brakes is the normal location but it could also be the front or on the drive shaft on a rear wheel drive.
To put a Chevy Trailblazer into four wheel driver, locate the four wheel drive component below the instrument panel. While the car is in drive, move the knob into the desired four-wheel drive position.