To program your DISH Network remote to your TV there are a few different DISH Network remote codes that you can try & will need in order to successfully program your remote to the TV. The DISH Network remote codes for your Curtis Mathes TV will be one of the following, 516, 531, 595, or 253. If you are unsure how to perform the steps to program
If you are referring to a Curtis Mathes TV, then there are a few different DISH Network remote codes that you can try & one should successfully program your remote, 516, 531, 595, or 253.
If you are referring to a Curtis Mathes TV, then there are a few different DISH Network remote codes that you can try & one should successfully program your remote, 516, 531, 595, or 253.
I just bought Curtis ledvd1975A TV/DVD combo. I have tried every RCA, SONY, Sylvania code as suggested by other message boards in the Comcast site. I have the Xfinity remote. Any ideas for other codes to use?
I found remote replacements for this model at the following website:remotehound.com. It is $29.95. Supposedly you can also use a universal remote but none of the remote codes I have found on line seem to work.
You may find some website that sells new remote controls by googleing (on your PC search engine) the words "remote control." I bought one for a friend on the internet, i think, about ten years ago but can't remember the website.
owner manual states it must be programed by dealer
the code for Curtis dvd1041
To program your DISH Network remote to your Orion TV you will simply- press and hold the TV Mode button on your DISH Network remote, until all the other mode button back lights illuminate, then release. -Now while the TV mode button is blinking enter in the remote code; 720 which is the remote code for your Orion TV. After entering 720, then press the pound (#) key. -After pressing the # key on the DISH Network remote, the TV mode button should blink 3 times and then turn off completely. This will mean the programming of the DISH remote to your TV has been completed successfully. While still in TV mode try any of the functions on the remote, such as turning the volume up or down on your TV or attempting to press the power button. -The DISH Network remote should now be programmed to control your TV. -If the remote code 720 doesn't program the DISH Network remote successfully you can also try the following using the same procedures, 220, 748, 721, or 062.
subnet mask
Press TV button until it stays on. Enter the Code : 720 Press # You should be ready
check the ip of the remote computer and yours, use ipconfig command
You can gain remote access of your network from a distance by purchasing a remote server. It will allow you to use your network at remote locations. You can also purchase a network adapter to use your internet at school or at work or while traveling.