How do you program universal remote?

Answer 1

These days, almost all the electronic gadgets are accompanied by the remote controls. Programming a remote control is as easy as it is to use it. Remote controls come with codes and some without codes.

To program the remote with the codes, firstly, turn on the electronic gadget for which you are going to use this remote, by pressing the On and Off button. Then locate the Setup or the Code Search key on the remote control. These buttons may vary from remote to remote. Just hold on the setup or the code search key for 5 - 10 seconds or till the light on the remote turns on. Again it depends on the different remotes that the light will blink or be steady. If you are programming for your TV, press the TV button on the remote or whichever electronic device you are programming your remote for. Now use the numbers on your remote to enter the 3 or 4 digit code for the device. These codes are given in the manual given with the electronic gadget. If you have lost the manual, these codes are easily available on the internet too. Once you have found the code, enter it and you will notice that the light on your remote control has turned off. Now try using it to switch off your electronic device with the remote and if you can do that, your remote has been programmed.

As for the remote controls that come without the codes, the programming is a bit different and a little time consuming. After the light on the remote has turned on, start pressing the Up button for channels on your remote. You may have to do this many times, may be 5 - 10 minutes. As soon as the channel changes, your remote is programmed. Now turn your electronic device on and off from your remote to finish programming.

However, if you are not able to program your remote with the Up channel button, try it with the Power button on the remote. Press the button a few times till the device you are programming gets turned off. When it does get turned off, you have successfully programmed your remote control.
The Answers community requested more information for this question. Please edit your question to include more context. Universal what.

Answer 2

press and hold SET button until led light starts su shine

then pres POWER button. Light is gonig to blink, when something happens on tv, ex. Volume up, then press SET again and that is it

Answer 3

The specific instructions on how to program a Chamberlain garage door remote control will depend on the specific model number. Instructions can be found in the products instruction manual, or on YouTube.

Answer 4

you hold the mode you want to program while you enter the code, then let go, and depending on the remote,( i have a SANYO RMT-U130) it will blink

Answer 5

You need to use the pamphlet that came along with the remote control. You need to put in the code number for your TV.

Answer 6

press source on your remote, navigate to upper right side of your tv, choose universal remote setup, follow the further instruction on your tv

Answer 7

read the instructions

Answer 8

Tv codes for Mitsubishi