you have to take it to a dealership you have to take it to a dealership Answer !!!! No you do not have to take it to the dealer.. Call a Locksmith Dealers hose you.
You can program your Kia Sedona remote, by holding the lock and unlock keys at the same time. The red light will flash until the remote is program. When the remote is program. The red light will stay constant.
If the key starts the car and you just need to program remote. I just bought a 2000 beetle and had this same problem. Just unlock the rear hatch and lift it up, then unlock driver door with key and push either lock or unlock and it will program the remote to lock, unlock, doors rear hatch and arm alarm
You should be able to get in the Explorer , lock the doors if you wish , and then start the vehicle . That's what I do on my 1995 Explorer XLT
Cycle the key on/off 8 times and the door locks will lock and then unlock. Press the lock button on your key fob to program it
A Bulldog Security Remote Starter is a keyless entry system designed for use in vehicles. It allows you to unlock the car and even start the engine from a distance of up to 800m.
Turn the ignition key at a normal rate on and off about 8 or 9 times. (not to the point where the starter would engage) Your door locks will lock then unlock automatically, when this happens, press a key on the new remote. You new remote should now work.
You have to press the unlock button 2 or 3 times to get both doors to unlock no programming needed
To program a 2007 GMC Envoy remote, close all the doors. ?æInsert the key in the ignition while holding the unlock button on the drivers side. Turn ignition from on to off twice. ?æNow release the unlock button. ?æThe fob is ready to program.
AnswerHave all of the available remotes in hand, put key into ignition and cycle key 8 times rapidly, ending in the on position (on & off = 1 cycle, do not engage starter), door locks will cycle, letting you know that the vehicle is in program mode. To program remote, push the unlock button on each clicker, to close programming, turn car off.
While holding the door unlock button on your driver's door, turn the key to ON then OFF, then ON, then OFF. Release the unlock button and the doors should lock/unlock to confirm the PDM is in programming mode. Then hold the door unlock and door unlock buttons on your remote at the same time. After about 15 seconds the doors should lock and unlock to acknowledge that it's picked up the remote. Program all remaining remotes at this time. The system will take up to four remotes.
On my 99 turn key from off to on (don't start vehicle) 7 times--doors will lock and unlock, then push any button on remote to program. Maybe the same on 2003
Try turning the ignition on and off about 10 times until the door locks, lock and unlock, then lock with the remote done.