0
by connecting ampere meter in series with load.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
How is power caculated?
The power used up by any electrical load is . . .(voltage across the load) x (current through the load) or (voltage across the load)2/(resistance of the load) or (current through the load)2 x (resistance of the load). These are all completely equivalent, and you have your choice of which oneto use, depending on which numbers you know or can measure.
How is electrical power caculated?
The power used up by any electrical load is . . .(voltage across the load) x (current through the load) or (voltage across the load)2/(resistance of the load) or (current through the load)2 x (resistance of the load). These are all completely equivalent, and you have your choice of which oneto use, depending on which numbers you know or can measure.
What are the units of measurement for current load and amperage?
The unit of measure for current load is amperage, or simply amps.
Where does the volmeter and ammeter go in a circuit?
after incomer & before outgoing feeder, we connect ameter to measure amps.AnswerThe voltmeter is connected in parallel with the load and the ammeter is connected in series with the load, if you wish to measure the potential difference across, and the current through, that load.
How do you measure current without connecting the load?
Without load there is no current so it is impossible to measure it.
Reactive current through the inductive load produces?
Reactive current through inductive load produces -- Magnetic field
Why no load current is 5 percent of full load current in motor?
As the no load current is the current due to core losses of the motor which is very small .in no load terminals are open circuited no current flows through it, a small current flows which is due to core
How do you measure no load current in a stabilizer?
It measuring by pressing the red button
What is offload device?
an off-load device a a switch where there is no current passing through it when its switched, a isolator is a off load device, a light switch is a on-load device because there is current passing through it when its switched.
How you can check load connected of transformer?
Measure the current and voltage on the secondary side.
Why less current increases in transformer than in induction motor when load is increase?
The current flowing through a transformer's secondary is the current drawn by the load, so it will be exactly the same as the current flowing through your induction motor -assuming that is the load. Don't really understand the point of your question!
Do charges move from a source of potential difference into a load or through both the source and the load?
As the circuit must be a closed loop, the current passes through both the source and load. If it was not a closed loop no current could flow anywhere.
