This belt is tightened by a manual system. The key is to loosen the bolt located on the tensioner pully, then loosen the adjustment bolt located above and to the left of the pully.
For the 4.0L, there is an adjustment bolt behind and on the engine side of the Power Steering pump. It runs diagonally behind the pump and the tension pulley. In order to loosen the tension, the bolt on the tension pulley must be loosened first. This pulley is the one below the power steering pump. Tighten the pulley bolt again once the adjustment has been made.
The wind will lessen soon, and we can go back outside. If you lessen the tension on the sewing machine, your stitches will be more even.
Detente is the foreign policy strategy was thought to lessen tension with the Soviet Union. The foreign policy problem that eventually forced Lyndon Johnson out of politics was the Vietnam War.
There should be a diagram showing the twists and turns you have to follow located in the engine compartment(mine is near the top of the rad steel plate cover I think)uus a heavy long screwdriver or some steel wedge to push the tensioner pully (to left) to lessen the tension to get the old one off and the new one on. Keith
Poor whites shared a common interest with upper-class whites in maintaining social control over blacks.
it allowed japan to visit relatives... i think
The homophone for "lessen" is "lesson."
Lessen the thickness with more water.He decided to lessen the volume.
If you dig a hole you lessen
The homophone for lessen is lesson.
To ease tension on a pogo stick, try stretching before and after using it to loosen up your muscles. Make sure to take breaks to rest and avoid overexertion. Additionally, adjusting the pogo stick's pressure can help provide a softer bounce and lessen strain on your body.
Earthquakes relieve the tension building between tectonic plates. so, loads of small earthquakes lessen the chance that a massive earthquake will happen along the same plate boundary.
Paraphrasing from the service manual: 1. disconnect the battery. 2. Remove the cooling fan next to the alternator. 3. Put a wrench on the idler pulley and move it to the rear to lessen the belt tension. Remove belt. 4. Remove alternator connections 5. unbolt alternator plus one bolt holding a wire.