Removal of serpentine belt: Directly below the alternator you will see a small idler pully, below that a tension pulley on a long trianglular arm. A 3/8 ratchet will fit right into the square hole near the bottm of that arm, pull up and towards you and the belt will go slack, just pop it off the alternator and then slowly let off the pressure on your ratchet (it will snap back with a fair amount of force and pinch your fingers if you let the ratchet slip).
Removal of Alternator: Remove the 8 bolts attaching the two motor mounts to the front of the van, rotate them upwards out of the way. Use a floor jack with a block of wood on top of it to lift on the transmission. This will roll the engine forward (much more safely than putting the van in gear and rolling it forwards). Disconnect the battery then remove the wires from the alternator. Behind the alternator, facing upwards toward the firewall are two bolts (15mm) remove the front one completely, the back one (drivers side) is slotted and only has to be removed half way. Remove the third bolt, the one you can actually see at the front of the alternator. Roll the alternator back out of the front pivot and lift up and out.
Installation : Reverse of removal instructions. There is a diagram of the route the belt takes on the front of the engine, normally on top between water pump and Power Steering pump, occasionally on the front panel by the hod latch.
on my 2000 Chevy Venture, it's the one that sits pretty much on the top of the belt drive.
Remove the belt from your 2000 Pontiac Trans Am alternator. Remove the wiring harness from the back of the alternator. Remove the alternator retaining bolts. Reverse the process to install your new alternator.
The 2000 Dodge Caravan alternator can be changed by removing the alternator belt. Remove the wiring harness from the back of the alternator. Loosen and remove the alternator retaining bolts. Install the new alternator by reversing the process.
How do you install an alternator belt on a 1986 GMC s15 pickup truck
Begin by removing the alternator tensioner bolt. Slide the alternator to the left. Remove the alternator belt. Reverse the process to install the new alternator belt.
Remove the alternator belt from your 2000 Chevrolet Monte Carlo alternator. Remove the wiring harness from the alternator. Remove the alternator retaining bolts. Reverse the process to install the new alternator.
When replacing the alternator on a 2000 Chrysler Sebring convertible begin by removing the belt. Next, remove the wiring. Lastly, remove the retaining bolts. Reverse the process to install the new alternator.
Start replacing the 2000 s10 alternator by disconnecting the battery. Remove the air inlet hose, and the serpentine belt. Take off the bracket over the alternator if it has one. Unbolt the alternator and disconnect the wires. Reverse the procedure to install the new alternator.
Loosen the tensioner pulley. The alternator belt will become loose. Take off the belt. Remove the wiring harness from the alternator. Remove the retaining bolts from the alternator. Remove the alternator. Reverse the process to install the new alternator.
Remove the alternator wiring harness. Loosen the tensioner pulley. Remove the alternator belt. Remove the alternator retaining bolts. Reverse the process to install the new alternator.
Disconnect the 1991 Regal battery. Remove the alternator belt and wiring. Unbolt the alternator and install the new one. Reconnect the wires, install the belt, then reconnect the battery.
how to replace the alternator belt of a mitsubishi montero 2000 ?