There is another fuse panel above the one you see under the driver's dash. Drop down the one you see and pull the fuses for the alarm on the fuse panel above it. This will also disable your radio.
Get a repair manual for your truck, because you will need to cut the wires out of the ignition switch, and bypass the alarm.
To disable a kill switch the wiring would have to be modified to bypass the switch. This is not advisable as the switch is a safety feature.
Most cars have a switch to disable the cruise control. To permanently disable the cruise, remove the fuse for the circuit.
There isn't a switch there from the factory.There isn't a switch there from the factory.
Your new key chip needs to be mated to the cars computer, this needs to be done at the dealer
go to the pass door and lock/unlock 2 or 3 times to deactivate the alarm switch in the door latch. If battery is weak/low it wont solve problem, must replace battery.also check for broken hood pin switch($5.00) as they are likely to be broken on a 94 veh. and when failed will cause security system to activate causing security light on dash and no start condition/lights flashing etc...pain in the @#%$%. On 1994 Jeep GC, disable the factory alarm by turning the key (lock/unlock) in the rear hatch. The alarm will then be turned 'Off".
A kill switch is used to disable the motor of a jet-ski if the rider falls off.
No.
Quick, disable the alarm, the rozzers are on their way!The fall was enough to disable him for life.The disable switch is located on the roof of the elevator car.
must be a Ford.......factory defect because the cruise hot wire stays hot all of the time and melts the switch XXXXXXXXXXXXXXXXXXXXXXXXX ANSWER XXXXXXXXXXXXXXXXXXXX No matter what the car is, you need to contact the dealership as there is possibly a recall on it.
The lock out switch will disable all of the door lock and window switches except for the master switch. It is used in case you have kids and want to disable their switches.
There is a disable switch called (valet switch) under the driver side of dashboard. Switching to opposite position should disable the alarm system.