With a Step Down transformer. But you will probably have a hard time finding a 240 volt unit. 120 volts units are readily available.
<<>>
It depends on how big of a transformer that you are looking for. There are many control Transformers in the 50 to 500 VA range that have dual primary and dual secondary. The primary side can be connected to 240 volt or 120 volt and the secondary can be connected for either 12 or 24 volts.
The only way to do that is with a transformer. They make inline transformers that convert 230 to 115 and they simply plug in inline.
Yes, 220 volts is in the same voltage classification as 230 volts.
Converting 9 volts to 230 volts would require a pretty hardcore step up transformer (Expensive) and you probably wouldn't have enough current to sustain the load.See discussion page for more information.
There in no quick and inexpensive way of doing this conversion. A transformer would have to be used and this type of winding is not common. 277 volts is the wye voltage of a three phase 480 volt system.
The classification of 230 volts is in the low voltage range.
In the US the voltage is about 220 volts. This voltage is based upon the average voltage of the AC sine wave. It can peak as high as 240 volts or as low as 210 volts. So these different voltages are actually referring to an average 220 volt system.
The 440 volts listed on the cap is the maximum allowable voltage the capacitor can handle. You could actually use a 370 volt cap on 230 volts. ANSWER; 230 volts AC can it actually be 644 volts peak to peak . It is 44ov because it must be rectified and sees only 324 volt peak which is withing the 440 volt capacitor handling voltage
A step-up transformer would be required to supply 230 volts from a 220 volts source from South Africa.
Yes you can run a 400 volt heater on 230 volts but you will not get the full wattage rating that the heater produces at 400 volts.
That is called an inverter.
In North America you can not obtain 230 volts from just one single pole breaker. The distribution is like this, from a one pole breaker to neutral is 120 volts. From an adjacent breaker to neutral is 120 volts. From the adjacent breaker to adjacent breaker (breakers situated beside each other) the voltage will be 230 volts.If you want to incorporate a 120 to 230 volt transformer into the circuit you can obtain 230 volts. The primary side of the transformer will be connected to the 120 volt circuit and the secondary side of the transformer will output 230 volts. The transformer must be sized to the load amperage or the load wattage of the connected 230 volt load.
400 volt three phase on a grounded system is 230 volt single phase, with each phase 120 degrees apart. So, if you have a 400 volt, three phase four wire service (grounded service), you can pull one phase off and reference to the neutral for 230 volt service. Note this may not allow 115 volt service, unless there is also a center tap for each phase.