BUY..
A NEW THERMOSTAT FOR THE CAR 1ST
ANTIFREEZE
GASKET SEALER
Follow the top hose from the top left of the radiator back to the engine block, where the hose ends attached to a metalic dome (thermostsat housing), held inplace by a pair of 3/8 or 10mm bolts. Remove bolts and take em out of the holes (stops them flying off into the engine in a place where you cant get them back). Lift off the thermostat housing and remove old thermostat after checking which way it sits in place.
Use a clean rag to fill hole while you clean away any residual gasket debris. Fit new thermostat, Use gasket seal on the new supplied gasket replace housing.. and bolt down tight.. refill system with recommended antifreeze and run the engine and check for leaks and top up levels as required..
DIFFICULTY: Low 20 mins max
Chrysler does not have reset switches.
Its in the fuel tank
No.
.044 inch
10w-30
It is on the lower portion of the passenger side of the firewall.
1 4 3 2
firewall passenger side lower
Auto-Repair-Manuals.com
There could be a few reasons why a 1990 Chrysler Lebaron will crank but not start. The fuel pump could be out or the car could be out of gas. There may be a malfunction in the ignition system causing no spark.
how to change a thermostat on a 1990 Nissan pintara
quick conts? get the tool from autozone.