If you are replacing it with a new one, unplug the sensor from the harness, cut the wires off at the sensor, slip a 7/8" box wrench over the sensor and with a counterclockwise motion remove the sensor from the exhaust pipe. Install the new one using a 7/8" open end wrench and tighten as you would a spark plug, reconnect the wires to the harness.
To replace the oxygen sensor on a Honda Odyssey, first unscrew the sensor. Then use a 22 mm socket or 7/8 inch wrench to replace the oxygen sensor.
22
Possibly the Lambda sensor (oxygen ) at Daewoo i was quoted £114 but you can get the online for about £22 to £28 search for lb1000 lambda sensor also fits a lot of vauxhals
22- Coolant sensor signal out of range22- Coolant sensor signal out of range
WARNING: THE EXHAUST MANIFOLD, EXHAUST PIPES AND CATALYTIC CONVERTER BECOME VERY HOT DURING ENGINE OPERATION. ALLOW ENGINE TO COOL BEFORE REMOVING OXYGEN SENSOR. # Raise and support the vehicle. # Disconnect the wire connector from the O2S sensor CAUTION: When disconnecting the sensor electrical connector, do not pull directly on wire going into sensor. # Remove the O2S sensor. Snap-On oxygen sensor wrench (number YA 8875) may be used for removal and installation. == Threads of new oxygen sensors are factory coated with anti-seize compound to aid in removal. DO NOT add any additional anti-seize compound to the threads of a new oxygen sensor. # Install the O2S sensor. Tighten to 30 N·m (22 ft. lbs.) torque. # Connect the O2S sensor wire connector. # Lower the vehicle.
I have an 89 s10 with a 2.8 V6. It gets about 22 city, 25 highway.
there are 2 sensors on this model one located on the fron pipe and one on top of the manifold you replace them both the same disconect the sensors wire and it will be a 22 or 24 mm nut replace the same way as you took it out.
Oxygen Sensor Circuit (Rich Exhaust). This may of may not be a defective O2 sensor. It may be something else that is effecting the O2 sensor. But considering the vehicle is 22 years old, I would suspect the O2 sensor needs replacing. I would replace the O2 sensor.
The code 22 in a Toyota vehicle is for the water sensor.
The timing marks for the cam sprocket on a 98 S10 is on the front. The marks for the crank shaft is on the oil pump gear.
22 foot/lbs
22- Coolant sensor signal out of range. It might have been disconnected by accident for some reason or could be a bad sensor... Its the sensor that's screwed into the engine block with a 1 wire connection.