My toro weed trimmer motor revers up super high when choke is taken off, when hit the gas to trim weeds goes even higher on rpms. Have checked oil to gas mix several time thinking was wrong, good there. How do I adjust the idle lower?
Most two stroke engines have a gas fuel line that feeds the carburetor. My Toro gas powered trimmer had 3 separate pieces of lines. The main line that feeds the carburetor, another short one going from the carburetor to the Bulb, and a third to siphon the excess back to the fuel tank. In my case, the main line had ruptured. First thing was to disconnect the spark plug and empty the fuel tank. I captured the piece that had dropped into the fuel tank as that had the fuel filter attached to it. I then unscrewed the fuel tank (as it made it easy to work afterwards in the small space provided). I pulled out the other end of the broken line and pulled it out of the carburetor (using a long nose plier). Cutting a similar length (actually an inch longer) of the new fuel pipe, I cut on end at a slant (like a taper) and used this end to insert into the small hole going into the fuel tank. Once inside I pulled this out toward the gas cap, cut off the end and attached the fuel filter. Then I dropped it back into the tank and gave it enough line so as to sit the filter into the bottom of the tank. I attached the other end to the carburetor and re-attached the fuel tank.
A line trimmer, also known as a string trimmer, is used to trim grass or weeds. The piece of equipment also goes by the name of a weed eater, or weed whacker.
no
You remove the bottom cover off the weed trimmer, and remove the tangled old wire. Insert the new wire into the side of the trimmer and wrap it around the black spindle.
40:1 owner's manual for a homelite st 185 trimmer says 32:1
Weed trimmer line is made from hardened monofilament nylon of varying thicknesses. PA6/66 copolymer nylon is commonly used in weed trimmer line.
weed-ate, or cut with the string trimmer
Nylon
The Weed Eater Electric Trimmer is one of the easiest to use
what is the gas/oil mix for the 24cc weed trimmer by craftsman
I solved my own problem,my weed trimmer has a on and off switch the wire in the switch had a bare place that was shorting out, by lifting the trimmer I was putting pressure one the bad connection.
weed-whacker- for trimming ground plants/weeds trimmer- for trimming bushes or shrubbery
pray