answersLogoWhite

0


Best Answer

To change the front turn lights (indicators) on a Mazda Tribute (2006 Australian model), turn the wheel away from the side you are working on, then undo the screws holding the forward sections of the mud guards located within the forward section of the wheel arch (on the 2006 model they require a shifting wrench or equivalent ratchet). Then pull away the mud guard which will still be attached but will give you room to get your hand inside. Reach forward through the gap up to approximately where the back of the turn light is and feel for the rear of the light - clasp the connector and twist anti-clockwise to release and withdraw the connector and bulb. Pull this out of the gap (there is enough cable to do this) and then change the bulb. Then reverse this procedure. It is a bit cramped but it is relatively simple. I did this and found the bulb was not blown, it was simply dust in the connector so take a close look at the bulb, test it when you have it out of the wheel arch as it may simply be dust in the connector. I recommend changing both left and right bulbs if one is blown (they will have a similar lifespan).

See sources and related links below for light bulb info.

User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you change the front turn light bulb in a Mazda tribute?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

On a mazda tribute what does the car with a key light indicator mean?

On a Mazda tribute, the car with a key light indicator means that the engine is started.


Check engine light Mazda Tribute?

The check engine light on a Mazda Tribute gives warning of potential problems. It can signal overheating, low oil, or engine misfires.


2003 Mazda tribute daytime running lights relay where is it located?

Where is the module light day on Mazda tribute 2003 4 cylindre


How to fix the Mazda tribute airbag light?

There are plugs under the front seats for the air bag wiring. unplug then replug the wires and the light should go out. It worked on my 2002.


How do you you reset change oil light on a Mazda?

Reset the change oil light on Mazda 3


Engine light on a 2001 Mazda Tribute?

After correcting what the initial problem that caused the light to come on, I was able to disconnect the negative terminal of the battery for about 1-2 minutes and the light went away. I hope this helps... "01" Mazda Tribute 3.0L V6


2003 Mazda tribute why does the airbag like stay on?

The airbag light on a 2003 Mazda Tribute will stay on if a defect is detected in the system. This can include the sensor or the airbag itself which should be immediately repaired.


Are airbag light problems common on a 2002 Mazda Tribute?

This airbag issue is part of a recall by Mazda. You should contact your dealer.


Dash gear indicator light stays on?

Short in dash cluster is common on mazda tribute


Mazda tribute engine light?

When the check engine light comes on, it's a good indication that something is wrong with your engine.


What is the gazebo looking dashboard warning light on a 2003 Mazda tribute and why does it stay on for a minute before shutting off when you initially start the car?

"What is the gazebo looking dashboard warning light on a 2003 Mazda tribute and why does it stay on for a minute before shutting off when you initially start the car Mazda tribute and why does it stay on for a minute before shutting off when you initially start the car?"


How do you change the front parking light on your 2003 Mazda MPV?

JKack up the horn and put a new car under it