Disconnect the negativ battery cable whenever working with anything electrical on a car. Then take the cap off and see where the rotor is pointing. Then remove the dist and make sure the new rotor is pointing the EXACT way the old one was when the dist is fully installled in the oil pump. Then the timing will have to be set with a light. To do this every car is different and you need a manual to do this. On the rotor simply remove the screws and remove the rotor./
Disconnect the battery negative cable.Mark each distributor wire before you disconnect them- it makes it alot easier to hook back up.. If youn have the cover plate still on over the distributor remove it.With a felt pen mark on the plenum and distributor side by side-this is your timing mark-it's crude but with out a light it will work.My distributor was red so the felt pen mark showed up. You might have to use the base of the distributor to get the mark.Next mark the position of the rotor. It must go back into the original postion-if your are close it will only go in one way the oil pump pickup is on the botton and these two must mesh for the distributor to go all the way down.It will only go down all the way 2 ways the right way and 180 degrees out.Remove all the connectors on the side of the distributor, loosen off the bolt on the passenger side, lift up the distributor and unplug the 4-way connector on the back. Change the rotor by removeing the two screws.If your this far-I'm sure you figured that part out.
Not very for a mechanic. If you want to do it yourself get a shop manual. Make sure the negative battery terminal is completely disconnected. It just involves removing the air cleaner, distributor cap, and distributor hold down bolt (pretty sure is a 9/16. Also, are you sure you want to change the distributor? Did it fail, my 89 Caprice Brougham's distributor is fine. If you are getting bad ignition it is probably not the distributor. Check for cracks.
how do u change front signal lights for corvette 1999
how to change a fuel pump in a 1998 Chevy Corvette
ALL STANDARD ROTATION SB CHEVY MOTORS ARE 1-8-4-3-6-5-7-2. YOU CAN CHANGE ROTATION FOR BOAT APPLICATION WITH DIFFERENT CAM, ADD CAM THRUST BEARING AND DIFFERENT DISTRIBUTOR GEAR.
2015
== ==
Just changing the oil doesn't do anything to the gauge, hold reset button down until readout changes change the oil
No. The 91 Corvette has a larger roof panel than the 88 Corvette's. yes if you change the front anchoring brackets
== == how do you reset the oil light on a1992 corvette
How do I change the dimmer switch on my 1993 corvette?
how do you change out the distributor assembly on a 1989 ford f250
A distributor will change the way the car runs not the way it drives.