1. Turn the front wheels full lock toward the same
side of the vehicle as the lamp being serviced.
2. Disconnect and isolate the battery negative cable.
3. Remove the four fasteners securing the front of the
adjacent right or left front fender wheel liner to the
lower edge of the front bumper fascia (3) and the
outboard surface of the frame rail ahead of the
front wheel.
4. Reach between the front of the wheel liner and the
lower fascia to access the back of the front side
marker lamp unit housing (1).
5. Firmly grasp the front side marker bulb socket (2)
on the back of the lamp housing and rotate it counterclockwise
about 30 degrees to unlock it.
6. Pull the socket and bulb straight out from the
keyed opening in the housing.
7. Pull the base of the bulb straight out of the socket.
LAMP
NOTE: Vehicles manufactured for export markets do not have a bulb, socket or wiring provided to illuminate
the front side marker lamp. The front side marker lamp housing and lens are present, but serve only as a
reflector on export vehicles.
what year? and which parking light? side marker or in the headlight? 2005 Mazda 6 side marker light bulb
The interior of the car is whale penis
2005 jeep liberty 4wd 3.7l how to change diff.oil
Don't worry about breaking it, you will have to pop it out and replace the whole light. It usually run around $25 for a pair of lights.
Not to my Konwing
its easy just put a liitle of preasure on marker light push forward . it should come out. do the reverse to put back on after replacing bulb.
how to change out low beam on 2005 hyundai sonata?
Every 3 months or 3000 miles.
the answer is no. 2002 was the first year the liberty was made. in 2003 they change the computer modules..the only engine you can put in a 2002 jeep liberty is a 2002 engine
It is moderately easy to change the spark plugs on a Liberty, although it is rather tricky because of the gap between the spark plugs.
change the light bulb,
how do you reset the check engine light on a 2005 Toyota tundra