Make sure the sewage pipe is in good repair and has NO leaks then extend it to a facility where the sewage can be treated (turned into good water by mixing it with air to let the good bacteria break down the sewage).
It is possible to turn sewage into harmless, good products and to make the water clean again. This is a natural process (otherwise all the water on earth would be bad) and it is possible to make this process happen faster using waste treatment methods.
re-level the unit,and/or clean the coil
There are no exact products for sewage spill . Mainly people have come up with tons of ways to clean up and stop it for happening.
1. Replace the pipe, 2. Shut off the water
Repair the pipe of fixture to stop your leak.
Repairing the section of pipe that is leaking will stop a leak on a hot water line.
no it wont the acid will stop it rusting xxx
Someone may have shut off the water to that faucet, or a pipe may have froze, or there may be air in the pipe.
You can dig to the pipe, clean it and roughen it, then use purple primer and Weld On 711 to repair it. . I would wait 12 hours for this to cure then do another coat of 711. - I have done this on PVC pipe that was carrying mains water at 85 psi.
It's a valve that regulates the main water pipe.
Yes and no but they will also stop water from running through the pipe all together if left unchecked and also destroy the pipe.
to stop condesation of water from the surface of pipe.
We use foam rubber to stop condesation of water from the surface of pipe.