0
How can you measure a time delay fuse with a multimeter to determine if it is good or bad?
Wiki User
∙ 14y ago
Set the multimeter for the "buzz" mode. This mode checks for electrical continuity. This means that the multimeter checks to see if there is a path for electricity to pass through. Some multimeters indicate it with a buzz, others with a light. Put one lead at either end of the fuse, and if the indicator (buzz or light) goes off, the fuse is good. If it doesn't go off, the fuse is broken. If you don't know how to set your multimeter on that setting, or it does not have one, set the multimeter to measure resistance. If the fuse measures a really small resistance, it is good. If it measures at a really large resistance, it is broken.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you check fuse with multimeter?
The current in the socket can not checked directly because the sockets are connected in parallel to the supplu and we can not measure current in parallel it is always measure in series so connect a lod to socket after that use ammeter in series to measure electric current.
What is the purpose of a fuse in a multimeter?
The purpose of a fuse in a multimeter is to protect the instrument and the user from excessive current. If too much current flows through the multimeter, the fuse blows, breaking the circuit and preventing damage to the multimeter or potential harm to the user. This helps ensure the safe and accurate operation of the multimeter.
What is the function of the time delay Fuse?
The time delay fuse allows a momentary overload due to startup current.
Where do you used a time delay fuse?
we use a time delay fuse at furnace area where heaters are used ect,
What is the difference between a fuse and a time delay fuse?
A time delay fuse will not blow at the first sign of an overload. It will delay blowing just long enough to allow a motor to start or a compressor to startup.
What is the difference between a slo-blo fuse and a time delay fuse?
There is no difference. Slo-Blo is just a trademarked name for a time delay fuse.
How do you know when a starter fuse is bad?
Use a multimeter to check if the fuse is still conducting current. Set the multimeter to read Ohms and place one lead on one end of the fuse. Put the other lead on the other side and see if there is a reading. If there is, the fuse is whole. If there is no reading, the fuse is blown.
What do the letters mdl stand for on a fuse?
Time delay fuse.
Why use a Time delay fuse versus non time delay?
A time delay fuse will allow for a temporary spike in the current (up to 100 or 200% of the fuse rating), such as when starting a motor. A regular (non-time delay fuse) will not allow for any spike over the current rating of the fuse. If you have a motor that pulls 2 amps while running, but pulls 6 ampls while starting, then you will want to use either a 6 amp non time delay fuse, or a 2 amp time delay fuse. If you are talking about pyrotechnics, a time delay (properly called a slow burning) fuse will give you more time to run for cover.
How do you check household fuses to find out which one is not working?
Use a multimeter set to continuity position and touch one probe from your multimeter to each conductor. If you hear a tone from the multimeter then your fuse is good.
Why does your multimeter keep blowing its fuse?
always have multimeter on the highest setting and always Disconnect it from the CIRCUIT BEFORE switching from one measurement to another.
Can you use a time delay fuse in your central air conditioner of the same amp rating?
Yes, and you should use a time delay fuse.
