Yes. Turning off any device when it is not in use will save power and energy.
Turning off the power or disconnecting anything while it is saving may cause either: * A Rollback, not being saved or the save file being rolled back to a previous save * It may corrupt the whole file so it won't be accessible. So you're going to have to delete/replace that file for it to work again.
you should be able to. If you havn't gotten to far ahead i recommend turning the game off and trying again
If its not in use.Turn off the juice Dont be fuelish A gallon saved is $3.00 earned Save today survive tomrrow Flip it off Lets cut carbs..... Our Carbon footprints that is You have the power to conserve You can stop energy disfunction Turn off the lights dont let the bill give you a fright
I received one from GTS By trading my level 90 Beldum... GTS only works if you Have Wi-fi.Or you can just save in front of Garitina and keep turning off and on till u find a shiny one.
Power Rangers are recruited to fight off against the evil forces of the universe regardless of whether they're fighting against sorceresses, machines, pirates, demons, mutants, creatures called Orgs that feed on the planet's pollution, mutant lizards, alien criminals, creatures that are undead and various other beings so that they can save the planet but also the universe from threats that are attacking it.
well by turning it off you save about over 1000 volts which could power 2 lights
Turning off the lights when not needed can help save electricity. Consequently, this can help save energy.
Try turning it off then on again.
A power cycle is turning off and turning back on any electronic device.
1: Turn off your Canon printer. 2: Remove its power cable from the power source to ensure that your printer is disconnected completely. 3: Wait at least 30 seconds. 4: Plug the power cable back in and connect the cable to the printer. 5: Turn on the printer.
To reset an HP Deskjet F380 All-In-One printer first turn off the printer. Disconnect the printer from the power source and wait ten seconds. Then, connect to the power source and turn the printer back on.
Lights use energy. Turning them off saves energy.
Double-check on the power button on the printer, make sure it's not stuck. If not, unplug the power adapter from the printer. The power adapter is the black box behind the printer where the power cord is attached. Wait at least 30 seconds before plugging it back in. That should refresh the printer. Hope this helps.
over 1000 volts
alot ... probably
Yes, you can
because then you'll lose your data.It dosen't automatically save