Does a 2002 Chrysler sebring have a vacuum modulator?
1 person found this useful
Answer Should be located at the engine end of the upper radiator hose On the 2.7 motor the thermostat is located at the engine side of the lower radiator hose. It's a diffi…cult job to change, the alternator a/c compressor and bracket need to be removed, at least unbolted and moved aside, and they have to be accessed from the passenger side inner fender as well as from under the hood. If you also remove the dipstick be sure to cover the hole so anti freeze can't get into the oilpan. I just unbolted the dipstick and moved it away without pulling it out to avoid that. Upon finishing I also had a problem with air pockets in the system when refilling with anti-freeze, the system must be bled well.
Answer . change the heather fan sensor
It is inside the transmission pan on the bottom of thetransmission.
The idle is computer controlled and is not adjustable.
21 city/28 highway
The data link connector is under the dash on the driver side.
It means your trunk is open
The transmission does not have a vacuum modulator. The transmission does not have a vacuum modulator.
The transmission on a Chrysler Sebring does not have a vacuummodulator. The transmission on a Chrysler Sebring does not have a vacuummodulator.
Engine, transmission, and abs are under the hood. Body, HVAC,airbag are in the vehicle. Engine, transmission, and abs are under the hood. Body, HVAC,airbag are in the vehicle….
Coolant temperature sensor circuit high. Check the sensor nearwhere the upper hose attaches to the engine to see if plugged in.
It is mounted to the floor, under the center console.
It is under the dash on the driver side.
It does not have one.