It's not necessary to run the engine.
With #1 at TDC, you can set 1, 2, 5, and 7 intakes, and 1, 3, 4, and 8 exhausts.
Rotate engine one revolution (#6 TDC) and set the rest.
If it's a hydraulic cam, tighten the rocker nut until there is 0 up and down movement in the pushrod, then tighten an additional 1/2 turn.
For solid cams, tighten rocker nut until specified backlash is achieved.
you don't really torque them, you tighten little by little as you shake them up and down until they are snug, the tighten just a little more, too much will leave you with bent pushrodsAnswerActuall, the 87 uses hydrolic roller lifters, so the procedure would be to just tighten them down. I believe that the torque spec is something like 24 ft. lbs. (you should look it up). Dont just tighten them down until the pushrods appear to be tight (as described in the first answer) or the nuts may back out and you will have big problems. Unless you have changed pushrod length or installed aftermarket rocker arms. If this is the case, you may need to purchase shims to maintain the proper rocker arm geometry.
There are many different men that leave their home running. This is because running is a very popular athletic activity.
tighten the faucet with the wrench and then spray the tiny cauliflower
It sound like your catalic convertor is stopped up. Unbolt it and drive it. If it runs a lot better, replace it or leave it off.
People leave their diesel trucks running because they think it is better. It is a truck with no spark plugs.
Start with 8qts. Run it - warm it up - shift it back and forth - leave running and top it off by the stick readings.
yes.
lol online never offline down with the trumpets off your rocker never leave london!
keep it running for short times
yes
You could leave your sink on.
the odor will get enbeded in the upholstory. Leave them outside for a while.