0
Do you have to remove the transmission to remove the engine on a 97 s10 blazer 4X4 automatic?
Wiki User
∙ 10y ago
No. You can remove the engine and leave the transmission in the vehicle.
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
Can you put a engine from a car with a automatic transmission in a car with a standard transmission?
Yes, but you have to remove the automatic transmission housing, and you have to replace the Torque Converter with a standard transmission clutch that matches the type of transmission with which you are mating the engine.
How do you remove 1998 blazer engine?
Begin by removing the engine wiring harnesses. Remove the motor mount retaining bolts. Disconnect the engine from the transmission. Lift the engine out.
Automatic Transmission 2000 Chevy Blazer 3-4 solenoid location TH4L60E?
They are bolted to the valve body, Have to remove transmission pan to service them.
How do you remove Engine and trans from 1996 blazer?
Remove hood remove radiator, remove a/c compressor, power steer pump do not dis connect a/c or PS hoses disconnect from engine, remove starter, remove motor mount bolts 2 long ones, disconnect wiring harness from engine and transmission, remove drive shaft from transmission. remove bolt from end of transmission, mount, remove fuel line, oil cooler lines, transmission lines if it's automatic, disconnect exhaust manifolds, ground strap, vacuum lines, throttle, cruise control cables, hook up your chain to engine & to hoist & remove slowly.
How do i replace a automatic transmission shift cable for a 96 chevrolay truck?
Remove the engine and drive shaft
Where is the automatic transmission drain plug on a 2000 Chevy Blazer 4.3 rear wheel drive?
there is no drain plug on that transmission.you must remove the transmission oil pan and wile your there replace the filter.
How do you take out a transmission out of a blazer?
I thought I could remove and replace the transmission in my Blazer, I did get it out but I didn't want to put it back in so I paid a local shop to come and get the blazer, transmission, and all the parts that had to be removed to get the transmission out and finish the job. I would suggest that since you are asking this question, maybe you would be better off going to a transmission shop in the first place. Mine is an automatic, a standard transmission would be much easier.
What is the best way to unbolt the engine from the transmission from a 350 k5 Blazer to remove or should you take the transmition out with the engine which is the best way?
I've always taken the engine out, leave transmission in. It probably depends on the shop equipment you have.
When changing the automatic transmission in a 1990 Accord is it easier to remove the engine and transmission as a unit How long does it take for an experienced mechanic to remove and install one?
Only the transmission needs to be removed. One day.
How do you change the front automatic transmission seal on a 1987 Chevy S10 Blazer with a 28 v6?
big job you have to remove trans or at least back it out enough to remove torque converter cause its behind it
How do you remove the automatic transmission on a Subaru Wrx?
how do you remove the automatic transmission from the 2004 wrx.... i have everything disconnected except for the gearing fork shifter.
How do you change a starter on a 1993 S10 Chevy Blazer with a V6 4.3 liter engine and automatic transmission?
The starter is bolted to the engine by two bolts which makes it very easy to change, just remove the bolts and drop the starter down until you can remove the wires from it, it is a good idea to remove the negative battery cable before starting the job to prevent arcing the wires to ground.
