It is best to remove the wall tiles. You need a flat service and a lot of times old tile will not be perfectly flat. If you remove the tiles you will have a good base to tile on. If you don't want to remove the tiles you may be able to add a backer board on top of the old tile and then tile on that.
I have tiled over cork tiles with ceramic tiles and it worked fine in a bathroom, around a bath. If the current tiles are really well fixed it should be fine.
It is possible but I would not reccomend it. If possible remove the old tile before laying the new tile. If you want to avoid removing the old tile you can lay a cement board over the old tile before installing the new tile.
I wouldn't recommend it. Most wall tiles are very smooth and wouldn't have any grit for the thin-set to adhere to.
That depends upon location. Tiles can be installed on a gypsum board wall or ceiling. (But make sure that the tiles are well grouted; if moisure gets past the tile into the gypsum board, it will be damaged.) Floors require greater strength - but then, you wouldn't normally have a gypsum board floor, with or without tile.
Tiles used on floors tend to be thicker than wall tiles. Also, floor tiles are subjected to flexing as people walk over them. Therefore, if floor tiling a wooden floor, use a flexible cement adhesive and grout designed to give and take without cracking.
no the tiles have too smooth of a finish and other tile will not stick to them need to remove old tiles and then lay new
wall tiles are used on walls. floor tiles are used on floors. if you want to interchange. you can make the wall tile as floor tile and vice-versa
Having tiles untold bathrooms I always do the floor LAST this saves dropping tiles etc on to the nice new expensive tile. However, when tiling the walls first leave out the bottom row of wall tile (here you can place your straight edge datum, put in the floor tile then set that last row of wall tile and leave a 1/8" gap between the floor and wall tiles and fill with same water proof grout as the floor tiles have
Ceramic tile contractors install ceramic tile floors in any room of a house, and they are specialized and do a great job. They also install other types of tiles, such as ceramic wall tiles, and ceramic countertop tiles.
You could but it's not advisableWall tile adhesive is thicker so it won't run down the wall and the tiles are less likely to slipANS 2 - I have done this a few times. If you use tile spacers, no problem.
I have tiled over cork tiles with ceramic tiles and it worked fine in a bathroom, around a bath. If the current tiles are really well fixed it should be fine.
YesANS 2 - I would only do that as a repair or an emergency. Floor tiles generally need a heavier and denser glue as they are being walked on - wall tile has no such stresses. ( -I have done lots of both types )
You can use 8"tile.
The most common wall tile is simply a white ceramic tile. These tiles are extremely cheap and easy to make and install. One can purchase them at a home improvement store.
The most important aspect is to make sure everyone is Safe. Using an OTLVISE to move the Granite will reduce the working load and allow you to roll it. Clamps as well to lift it with. Many patents with this NEW and Innovative tool
Neken.co.uk do a plastic wall tile panel. These can also be purchased in Focus, but they have less choice than the Neken website There is also a company called Stick and Go Tiles, they do a tile that does not need cementing or grouting, visit them on their website - 44 ranges to choose from. stickandgo.com now produce over 5O RANGES of tiles that do not need cementing or grouting, they have been in business for over five years and are an established company. The tiles are sold all over the world via their website.
You can, but it's best to start in the middle or offset half a tile in the middle of the wall. This will make the tiles in the corner the same size in both corners. Tiles in the corner should be wider than half the width of the tile.