How do you remove the driver s seat from a1997 mercury villager
The rear seat is not designed to be removed. You can remove the center seat and slide the rear seat forward.
You remove the center seat and slide the back one up into it's place.
The rear seat is not intended to be removed. You can remove the center seat and slide the rear on forward into it's place.
The rear seat isn't designed to be removed. If you have a center bench seat you can remove that by unclipping it, then slide the rear seat forward.
To remove the seats in the Mercury Villager you first need to pull the side lever and push the seat forward. Next, pull the release strap. Lift the back of the seat until the seat clears the latch. Pull rearward and remove from the vehicle.
The rear seat does not come out. The middle seat is removable, after which you can slide the rear one up.
there should be 4 bolts that hold the seat to the floor. just remove them and if it has power seat dont forget to unplug them.
unbolt it
You will have to remove the instrument cluster. This may be an LED that should never have failed.
You can not remove the third seat. You can remove the second seat and slide the third seat into it's position to get more room in the back. You can also put the third seat in the upright position and move it all the way to the front for more cargo room.
Apply pressure (usually kneeling is the best and easiest) on the rear of the seat and pull the seat towards the front of the car.