yes you can put a metal fitting on a plastic pipe but it is not highly recommended but if you must use it make sure that you wrap both fittings with Teflon tape in the opposite direction of the threads and be sure not to tighten to to tight this will cause the plastic to bust i hope this has helped
You will want to put a length of copper into the fitting and solder it before you put it on the galvanised so that you don't cook out the pipe dope. >>they also could have soldiered on a flange on copper and thread on galvanized pipe.would have been another choice
No, do not use glue. Use teflon tape or pipe dope on the threads. You should also make sure you always put the male PVC thread into the female metal thread. If you do it the other way you will tend to split the PVC fitting when you tighten the threads.
No, you'll need to put a pipe adapter on the PVC, then use a standard PEX crimp fitting. Or you can use a SharkBite fitting. They work well for this.
When you put metal in water it cools down quick. When you put plastic in the microwave, you're in for a big problem....Plastic is the answer.
Take either an SOS pad or a wire brush and rough up both the inside of the brass fitting and outside of copper pipe, put the copper pipe into the fitting and solder around it.
Install a ty fitting on the stack in the basement then run it to the sink. Put it low enough to account for a fall in the pipe, to allow proper drainage. Be sure to install a waste and vent pipe to code for both fixtures.
Yes but not metal
Did you put the ferrule on, the little brass ring?
it is when you reuse somthing, are you make thing for plastic, metal, and burnible then for example you put paper in burnibal, cans in metal, and bottles in the plastic
Chances are if you put a Pipe Wrench on the Pipe and turn it, you will damage the fitting that the Pipe screws into below ground. You should dig it up and use two Pipe Wrenches.
If it is leaking at a fitting, it is either a bad flare or it isn't tight enough. Gas or flare fittings should be put together dry, Do no use pipe dope because this can cause a leak between the mating surfaces. If it is in the line itself, either replace the line or cut it, flare the ends and put a fitting in.
electrolysis